Let the manufacture panelize and or creat the breakaways them for you. -----Original Message----- From: Edi Im Hof [mailto:[EMAIL PROTECTED]] Sent: Tuesday, January 21, 2003 3:04 PM To: Protel EDA Forum Subject: [PEDA] perforation
Hi all I'm curently designing a panelisied pcb. The panel is not the problem, but the break-away-tabs (or however they are called) I've created following thing: http://www.ihe.ch/temp/nutzen.pcb The large pads indicates the start/end points of the router bit. Is the perforation to strong / to weak / exactly right? How wide should the border be? This is a 1.5mm FR4 two sided mixed smd/th board. The break excess should be less than 0.5mm Any comments? TIA Edi Im Hof ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ + IH electronic + Phone: ++41 52 320 90 00 + + Edi Im Hof + Fax: ++41 52 320 90 04 + + Doernlerstrasse 1, Sulz + URL: http://www.ihe.ch + + CH-8544 Rickenbach-Attikon + E-Mail: [EMAIL PROTECTED] + + Switzerland + + ++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++ * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
