On 10:59 AM 20/12/2002 +1100, Danny Bishop said:
P99SE: Lomax Virtual short but make sure you are aware of the gerber resolution issues and tell your manufacturer what you have done. Go back through the archives for description of the Lomax virtual short. basically two pads very close but not touching (say 0.05 mils) and a suitable clearance design rule targeting just these pads allowing such a fine clearance. You need to produce gerbers with fine resolution to ensure that pads do not drift during plotting. The gap is too small to plot and too small to manufacture --> short.hi pplwhat is the easiest way to stop short circuit DRC errors (but still keep the grounds separate elsewhere) on a component that is just a copper trace that connects two different grounds in one spot.
DXP: use a NetTie component.
Ian
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
