Jami,
it was an arc along the edge of a polygon. The problem was with the
gerber creation, PCB file was fine, of that arc (actually "those arcs" since
there were a number of them) defining the edge of the polygon. It was the
gerber that was wrong and generating the opposing portion of the arc which I
actually wanted.
It was fixed by repairing the DDB, deleting everything within the
DDB except for the SCH and PCB files. I had to set-up new cam managers, CFG
files, PCB prints, BOMs, etc.. But something in that process fixed it, I am
not sure which fixed it because I did everything in one step I was so
pissed off.
Sincerely,
Brad Velander.
Lead PCB Designer
Norsat International Inc.
Microwave Products
Tel (604) 292-9089 (direct line)
Fax (604) 292-9010
email: [EMAIL PROTECTED]
http://www.norsat.com
Check out our fall promotion at www.norsat.com. Limited quantities. Sale
ends December 24, 2002.
Contact your Account Manager or call 1-800-NII-4LNB or email
[EMAIL PROTECTED]
> -----Original Message-----
> From: JaMi Smith [mailto:[EMAIL PROTECTED]]
> Sent: Sunday, December 01, 2002 11:08 AM
> To: Protel EDA Forum
> Cc: JaMi Smith
> Subject: Re: [PEDA] P99SE strikes again on a US vacation long weekend
> holiday.
>
>
> Brad,
>
> First, everything that follows is based on the assumption that you are
> talking about a problem with an "Arc", and not in fact a
> problem with a
> "Polygon", and if that is wrong, then trash everything that follows.
>
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
