Just cancel out of the wizard, when it comes up, and and you should get to the manual input mode (ie a "blank page") in the librarian. You can then place pads, number them, place line on the silkscreen layer to draw an outline for the part, ect.
Think by default it names the componet COMPONENT_1 or something, which you can just rename using tools, rename component, I think it is. ---Phil AK> Hi everybody, AK> Is the "new component wizard " the only way to go about creating a new component footprint in PROTEL or is there a way by which you can do it yourself (without using the wizard)? AK> please do reply, AK> thanks and regards AK> Anand Kulkarni * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
