I have a PCB in which two nets keep changing their net class. The nets are AC1 and AC2, they should belong to a net class called LV. However they keep changing to a class called HV (other members of this class are A, N, C, NO, NC).
They seem to swap whenever I edit a primitive associated with AC1 or AC2. There are no short circuits (DRC is ok if I move the nets to the correct class then run DRC before doing any editing). What is going on? This PCB was a V3 file but has since been updated and saved as a 99SE (SP6) v4 binary. --------------------------------------- Powercom Consultants Pty Ltd Electronics & Communications Engineers PH +61 3 62297966 Fax +61 3 62299245 --------------------------------------- * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * To post a message: mailto:[EMAIL PROTECTED] * * To leave this list visit: * http://www.techservinc.com/protelusers/leave.html * * Contact the list manager: * mailto:[EMAIL PROTECTED] * * Forum Guidelines Rules: * http://www.techservinc.com/protelusers/forumrules.html * * Browse or Search previous postings: * http://www.mail-archive.com/[email protected] * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
