THOMAS !!!
WONDERFUL - YOU LEGEND !!!!!
THANKS
Wayne
"Thomas"
<[EMAIL PROTECTED] To: "'Protel EDA Forum'"
<[EMAIL PROTECTED]>
m.au> cc:
Subject: Re: [PEDA] Holes
14/11/01 19:33
Please respond
to "Protel EDA
Forum"
I had one design in which the holes didn't show up when moving pads, and
one
that did. Very confusing until the penny dropped:
Turn the "Drill Guide" layer on (Design/Options - tick the "Drill Guide"
layer box). Viola! Holes show up when moving pads.
Tom.
> -----Original Message-----
> From: Abd ul-Rahman Lomax [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, 14 November 2001 2:16 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Holes
>
>
> At 12:47 PM 11/14/01 +1100, Thomas wrote:
> >Nope. I can still see a 0mm x 0mm pad with 1mm hole when moving it.
>
> Your eyesight must be very good! :-)
>
> [EMAIL PROTECTED]
> Abdulrahman Lomax
> Easthampton, Massachusetts USA
>
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Forum Guidelines Rules:
* http://www.techservinc.com/protelusers/forumrules.html
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
