Hi Richard,
I would suggest that you check your setup on Design Rules for the
autorouter. It may be that the spacing you are telling the program to
maintain is so large that there are no paths for the router to take that
would not violate the spacing rule.
- Bill Brooks
Bill Brooks
PCB Design Engineer
DATRON WORLD COMMUNICATIONS INC.
3030 Enterprise Court
Vista, CA 92083
Tel: (760)597-1500 Ext 3772 Fax: (760)597-1510
mailto:[EMAIL PROTECTED]
IPC Designers Council, San Diego Chapter
http://www.ipc.org/SanDiego/
http://home.fda.net/bbrooks/pca/pca.htm
-----Original Message-----
From: Richard Thompson [mailto:[EMAIL PROTECTED]]
Sent: Friday, July 20, 2001 7:08 AM
To: Protel EDA Forum
Subject: [PEDA] autorouter
Hi guys,
Can anyone explain why the autorouter is giving me this error message
please?
"one or more connections cannot be routed due to design rule violations"
this happens even if i try to just route a single component or net as well
as the whole board. i have done a done a complete drc (and online checking
is active) there are no errors/violations reported. i have tried removing
all of the design rules and it still refuses to play ball.
any ideas?
Rich
Richard Thompson
BLT Industries
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
