Hi people,
Sorry to repost this again, but the silence was unbearable :-) Can anyone
help / PLEASE?
Does anyone know how i can adjust the wiper position of a potentiometer in
the stepped value section of the simulator on Protel 99SE SP6. i can only
see options for stepping the actual value (pot total resistance)
Also can anyone point me to a formula or link to a spice model for a
logarithmic scale potentiometer for use within the simulator on protel 99se
sp6? ie. so that if i specify the wiper at 50% the resistance is not 50/50
but log law.
Are there any addons available for the simulator that will allow a dxf or
similar output of curves? it seems dumb that this cannot be done as default
(or is it just me?)
Help much appreciated
Rich
Richard Thompson
BLT Industries
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
* To post a message: mailto:[EMAIL PROTECTED]
*
* To leave this list visit:
* http://www.techservinc.com/protelusers/leave.html
* - or email -
* mailto:[EMAIL PROTECTED]?body=leave%20proteledaforum
*
* Contact the list manager:
* mailto:[EMAIL PROTECTED]
*
* Browse or Search previous postings:
* http://www.mail-archive.com/[email protected]
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
