I have a USB recording device that is controlled via a COM port. It basically accepts four commands from the supplied software. Start recording, stop recording, read data file from device and write configuration record to the device.
The software supplied with it is windows only and is very difficult to use. I want to write an application to control this device. I have written many such applications but I usually have the command set or have a way to "sniff" them out. Is there some way I can run the software and see what commands it is sending over the COM port? For you software police, there is no license or user agreement with the software. It is just supplied by the mfgr of the device to demonstrate it's capability. TIA -- Jeff Jeff Johnson [EMAIL PROTECTED] SanDC, Inc. 623-582-0323 Fax 623-869-0675 _______________________________________________ Post Messages to: [email protected] Subscription Maintenance: http://leafe.com/mailman/listinfo/profox OT-free version of this list: http://leafe.com/mailman/listinfo/profoxtech Searchable Archive: http://leafe.com/archives/search/profox This message: http://leafe.com/archives/byMID/profox/[EMAIL PROTECTED] ** All postings, unless explicitly stated otherwise, are the opinions of the author, and do not constitute legal or medical advice. This statement is added to the messages for those lawyers who are too stupid to see the obvious.
