I pulled a G5 I had sitting in a closed and followed the docs for macppc install. I booted from a CD and did a mbr install. At the end I see the installer installs a mp kernel as /bsd. The processor is dual core, so makes sense. Everything went fine and I rebooted to the Open Firmware ok prompt. When I try to boot /bsd I see the following:
[ using 1322900 bytes of bsd ELF symbol table ] console out [NVDA,Display-B] console in [keyboard], using USB using parent NVDA,Parent:: memaddr a2000000, size 20000 : consaddr 90020000 : ioaddr a1000000, size 1000000: width 1600 linebytes 2048 height 1200 depth 8 and it just sits there, and then after a bit the fans spin up. I power cycle the box, get to the Open Firmware ok prompt and boot /bsd.sp and it works. Full dmesg output from bsd.sp boot. [ using 1320548 bytes of bsd ELF symbol table ] console out [NVDA,Display-B] console in [keyboard], using USB using parent NVDA,Parent:: memaddr a2000000, size 20000 : consaddr 90020000 : ioaddr a1000000, size 1000000: width 1600 linebytes 2048 height 1200 depth 8 Copyright (c) 1982, 1986, 1989, 1991, 1993 The Regents of the University of California. All rights reserved. Copyright (c) 1995-2021 OpenBSD. All rights reserved. https://www.OpenBSD.org OpenBSD 6.9 (GENERIC) #874: Mon Apr 19 02:55:31 MDT 2021 dera...@macppc.openbsd.org:/usr/src/sys/arch/macppc/compile/GENERIC real mem = 2147483648 (2048MB) avail mem = 2045521920 (1950MB) random: good seed from bootblocks mpath0 at root scsibus0 at mpath0: 256 targets mainbus0 at root: model PowerMac11,2 cpu0 at mainbus0: 970MP (Revision 0x101): 2300 MHz cpu at mainbus0 not configured mem0 at mainbus0 spdmem0 at mem0: 512MB DDR2 SDRAM non-parity PC2-4200CL5 spdmem1 at mem0: 512MB DDR2 SDRAM non-parity PC2-4200CL5 spdmem2 at mem0: 1GB DDR2 SDRAM non-parity PC2-4200CL5 spdmem3 at mem0: 1GB DDR2 SDRAM non-parity PC2-4200CL5 spdmem4 at mem0: 1GB DDR2 SDRAM non-parity PC2-4200CL5 spdmem5 at mem0: 1GB DDR2 SDRAM non-parity PC2-4200CL5 memc0 at mainbus0: u4 rev 0x42 kiic0 at memc0 offset 0xf8001000 iic0 at kiic0 lmtemp0 at iic0 addr 0x4a: ds1775 maxds0 at iic0 addr 0x4b: ds1631 maxtmp0 at iic0 addr 0x4c: max6690 maxtmp1 at iic0 addr 0x4e: max6690 "dart" at memc0 offset 0xf8033000 not configured openpic0 at memc0 offset 0xf8040000: version 0x4614 feature 7b0302 BE mpcpcibr0 at mainbus0 pci: u4-pcie pci0 at mpcpcibr0 bus 0 vgafb0 at pci0 dev 0 function 0 "NVIDIA GeForce 6600" rev 0xa2, mmio wsdisplay0 at vgafb0 mux 1: console (std, vt100 emulation) wsdisplay0: screen 1-5 added (std, vt100 emulation) ht0 at mainbus0: u3-ht, 10 devices pci1 at ht0 bus 0 hpb0 at pci1 dev 7 function 0 "Apple Shasta PCI" rev 0x00: 85 sources pci2 at hpb0 bus 2 ppb0 at pci1 dev 1 function 0 "ServerWorks HT-2000 PCIX" rev 0xa3 pci3 at ppb0 bus 4 ppb1 at pci1 dev 2 function 0 "ServerWorks HT-2000 PCIX" rev 0xa3 pci4 at ppb1 bus 5 bge0 at pci4 dev 4 function 0 "Broadcom BCM5780" rev 0x03, BCM5714 B3 (0x8003)bge0: nvram lock timed out : irq 66, address 00:16:cb:39:54:c4 brgphy0 at bge0 phy 1: BCM5780 10/100/1000baseT/SX PHY, rev. 0 bge1 at pci4 dev 4 function 1 "Broadcom BCM5780" rev 0x03, BCM5714 B3 (0x8003)bge1: nvram lock timed out : irq 67, address 00:16:cb:39:54:c5 brgphy1 at bge1 phy 1: BCM5780 10/100/1000baseT/SX PHY, rev. 0 ppb2 at pci1 dev 3 function 0 "ServerWorks HT-2000 PCIE" rev 0xa3 pci5 at ppb2 bus 6 qle0 at pci5 dev 0 function 0 "QLogic ISP2432" rev 0x02: irq 65 qle0: firmware rev 4.0.20, attrs 0x2 scsibus1 at qle0: 2048 targets, WWPN 2100001b321ec356, WWNN 2000001b321ec356 ppb3 at pci1 dev 4 function 0 "ServerWorks HT-2000 PCIE" rev 0xa3 pci6 at ppb3 bus 7 ppb4 at pci1 dev 5 function 0 "ServerWorks HT-2000 PCIE" rev 0xa3 pci7 at ppb4 bus 8 ppb5 at pci1 dev 6 function 0 "ServerWorks HT-2000 PCIE" rev 0xa3 pci8 at ppb5 bus 9 ppb6 at pci1 dev 8 function 0 "Apple Shasta PCI" rev 0x00 pci9 at ppb6 bus 1 macobio0 at pci9 dev 7 function 0 "Apple Shasta" rev 0x00 macgpio0 at macobio0 offset 0x50 "smu-doorbell" at macgpio0 offset 0x12 not configured "smu-interrupt" at macgpio0 offset 0xd not configured "programmer-switch" at macgpio0 offset 0xc not configured "chip-fault" at macgpio0 offset 0xe not configured "slewing-done" at macgpio0 offset 0x38 not configured "mlb-good" at macgpio0 offset 0x13 not configured "vdnap0" at macgpio0 offset 0x14 not configured "timebase-enable" at macgpio0 offset 0x26 not configured "amp-mute" at macgpio0 offset 0x30 not configured "dig-hw-reset-c" at macgpio0 offset 0x9 not configured "codec-error-irq" at macgpio0 offset 0x32 not configured "codec-clock-mux" at macgpio0 offset 0x31 not configured "headphone-detect" at macgpio0 offset 0x2c not configured "headphone-mute" at macgpio0 offset 0x2f not configured "hw-reset" at macgpio0 offset 0xa not configured "lineout-detect" at macgpio0 offset 0x28 not configured "linein-detect" at macgpio0 offset 0x2a not configured "lineout-mute" at macgpio0 offset 0x2e not configured "escc-legacy" at macobio0 offset 0x12000 not configured zs0 at macobio0 offset 0x13000: irq 23,24 zstty0 at zs0 channel 0 zstty1 at zs0 channel 1 kiic1 at macobio0 offset 0x18000 iic1 at kiic1 "pcm3052" at iic1 addr 0x46 not configured "cs8416" at iic1 addr 0x12 not configured onyx0 at macobio0 offset 0x0: irq 28,11,12 "timer" at macobio0 offset 0x15000 not configured audio0 at onyx0 ohci0 at pci9 dev 11 function 0 "NEC USB" rev 0x43: irq 70, version 1.0 ohci1 at pci9 dev 11 function 1 "NEC USB" rev 0x43: irq 70, version 1.0 ehci0 at pci9 dev 11 function 2 "NEC USB" rev 0x04: irq 70 usb0 at ehci0: USB revision 2.0 uhub0 at usb0 configuration 1 interface 0 "NEC EHCI root hub" rev 2.00/1.00 addr 1 usb1 at ohci0: USB revision 1.0 uhub1 at usb1 configuration 1 interface 0 "NEC OHCI root hub" rev 1.00/1.00 addr 1 usb2 at ohci1: USB revision 1.0 uhub2 at usb2 configuration 1 interface 0 "NEC OHCI root hub" rev 1.00/1.00 addr 1 ppb7 at pci1 dev 9 function 0 "Apple Shasta PCI" rev 0x00 pci10 at ppb7 bus 3 pciide0 at pci10 dev 12 function 0 "ServerWorks K2 SATA" rev 0x00: DMA pciide0: using irq 10 for native-PCI interrupt pciide0: port 0: 1.5Gb/s wd0 at pciide0 channel 0 drive 0: <WDC WD2500JS-41MVB1> wd0: 16-sector PIO, LBA48, 238475MB, 488397168 sectors wd0(pciide0:0:0): using PIO mode 4, Ultra-DMA mode 6 pciide0: port 1: PHY offline kauaiata0 at pci10 dev 13 function 0 "Apple Shasta ATA" rev 0x00 wdc0 at kauaiata0 irq 38: DMA atapiscsi0 at wdc0 channel 0 drive 0 scsibus2 at atapiscsi0: 2 targets cd0 at scsibus2 targ 0 lun 0: <HL-DT-ST, DVD-RW GWA-4165B, Q002> removable cd0(wdc0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 4 "Apple Shasta Firewire" rev 0x00 at pci10 dev 14 function 0 not configured smu0 at mainbus0 iic2 at smu0 "smu-sat" at iic2 addr 0x58 not configured "smu-pulsar" at iic2 addr 0x6a not configured uhub3 at uhub2 port 1 configuration 1 interface 0 "Mitsumi Electric Hub in Apple Extended USB Keyboard" rev 1.10/4.20 addr 2 uhidev0 at uhub3 port 1 configuration 1 interface 0 "Fujitsu Component Apple Optical USB Mouse" rev 1.10/1.01 addr 3 uhidev0: iclass 3/1 ums0 at uhidev0: 1 button wsmouse0 at ums0 mux 0 uhidev1 at uhub3 port 3 configuration 1 interface 0 "Mitsumi Electric Apple Extended USB Keyboard" rev 1.10/4.20 addr 4 uhidev1: iclass 3/1 ukbd0 at uhidev1: 8 variable keys, 6 key codes wskbd0 at ukbd0: console keyboard, using wsdisplay0 uhidev2 at uhub3 port 3 configuration 1 interface 1 "Mitsumi Electric Apple Extended USB Keyboard" rev 1.10/4.20 addr 4 uhidev2: iclass 3/0, 3 report ids uhid0 at uhidev2 reportid 2: input=1, output=0, feature=0 uhid1 at uhidev2 reportid 3: input=3, output=0, feature=0 vscsi0 at root scsibus3 at vscsi0: 256 targets softraid0 at root scsibus4 at softraid0: 256 targets bootpath: /ht/pci@9/k2-sata-root/k2-sata@0/disk@0:/bsd.sp root on wd0a (5a778ff7783f5f8b.a) swap on wd0b dump on wd0b WARNING: bad clock chip time WARNING: CHECK AND RESET THE DATE! It does appear that I need a new battery. I also see this in the log: reorder_kernel: failed -- see /usr/share/relink/kernel/GENERIC/relink.log # cat /usr/share/relink/kernel/GENERIC/relink.log (SHA256) /bsd: OK make: don't know how to make newbsd Stop in /usr/share/relink/kernel/GENERIC Suggestions? Thanks, Tony
