Here is an excerpt from the fille - if you need any additional
information please let me know:

[    3.148635] zram0: detected capacity change from 0 to 3990952
[    3.151292] random: mkswap: uninitialized urandom read (16 bytes
read)
[    3.155451] Adding 1995472k swap on /dev/zram0.  Priority:-2
extents:1 across:1995472k SSFS
[    3.213537] squashfs: version 4.0 (2009/01/31) Phillip Lougher
[    3.397788] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.
[    3.425915] EXT4-fs (mmcblk0p2): mounted filesystem with ordered data
mode. Opts: (null). Quota mode: none.
[    3.483831] EXT4-fs (mmcblk0p2): mounted filesystem with ordered data
mode. Opts: (null). Quota mode: none.
[    7.818840] random: dbus-uuidgen: uninitialized urandom read (12
bytes read)
[    7.818901] random: dbus-uuidgen: uninitialized urandom read (8 bytes
read)
[    7.901892] snd_bcm2835: module is from the staging directory, the
quality is unknown, you have been warned.
[    7.911766] bcm2835_audio bcm2835_audio: card created with 8
channels
[    9.666428] bcmgenet fd580000.ethernet: configuring instance for
external RGMII (RX delay)
[    9.666713] bcmgenet fd580000.ethernet eth0: Link is Down
[    9.742246] Starting piCorePlayer v8.2.0 startup.
[    9.753828] cryptd: max_cpu_qlen set to 1000
[    9.803080] random: crng init done
[   10.154906] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.
[   10.224291] Bluetooth: Core ver 2.22
[   10.224651] NET: Registered PF_BLUETOOTH protocol family
[   10.224663] Bluetooth: HCI device and connection manager initialized
[   10.224680] Bluetooth: HCI socket layer initialized
[   10.224689] Bluetooth: L2CAP socket layer initialized
[   10.224709] Bluetooth: SCO socket layer initialized
[   10.228899] Bluetooth: HCI UART driver ver 2.3
[   10.228924] Bluetooth: HCI UART protocol H4 registered
[   10.229431] Bluetooth: HCI UART protocol Three-wire (H5) registered
[   10.230035] Bluetooth: HCI UART protocol Broadcom registered
[   10.259333] uart-pl011 fe201000.serial: no DMA platform data
[   14.781287] bcmgenet fd580000.ethernet eth0: Link is Up - 1Gbps/Full
- flow control rx/tx
[   17.065553] Bluetooth: BNEP (Ethernet Emulation) ver 1.3
[   17.065573] Bluetooth: BNEP filters: protocol multicast
[   17.065593] Bluetooth: BNEP socket layer initialized
[   17.083740] Bluetooth: RFCOMM TTY layer initialized
[   17.083774] Bluetooth: RFCOMM socket layer initialized
[   17.083801] Bluetooth: RFCOMM ver 1.11
[   28.817132] Finished piCorePlayer v8.2.0 startup.
[   31.709142] cam-dummy-reg: disabling
[  541.880161] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.
[  649.143248] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.
[  824.488072] FAT-fs (mmcblk0p1): Volume was not properly unmounted.
Some data may be corrupt. Please run fsck.


paul- wrote: 
> Can you go to the diagnostics page and look at the dmesg section.
> 
> Towards the bottom, you should see some lines about disk device
> detection,  can you copy those here. (Or just the entire section if you
> are unsure)


------------------------------------------------------------------------
Shozzer's Profile: http://forums.slimdevices.com/member.php?userid=58726
View this thread: http://forums.slimdevices.com/showthread.php?t=116915

_______________________________________________
plugins mailing list
plugins@lists.slimdevices.com
http://lists.slimdevices.com/mailman/listinfo/plugins

Reply via email to