DavidBulluss wrote: 
> Synching volume now turned off. Zone 2 tested 34507.
> Whwn turning on all is correct except QZ appears every few seconds on
> screen of AVR. Also, initially adjusting volume on LMS does not control
> the amp until I take the LMS volume very high then the amp vol jumps to
> life. After that no problems with volume control and QZ stops appearing
> on AVR screen.
> 
> Regards, David

It appears that you are running into the same problem as MarSOnEarth,
where the plugin is going into a Quick Select timeout retry loop after
powering on successfully. I am working on a code change to prevent the
retry loop but, as with Mars, I have no explanation for why the Quick
Selects are timing out, especially with the timeout interval of 5
seconds that was put in awhile ago to address timeouts you were having
when the interval was 2 seconds. If it's not too much trouble, I would
like you to go back to v4.0 and run the same power on sequence with
debug on so I can see if the timeouts are happening there too but being
compensated for in some way. You should probably just keep using v4.0
for the time being until I complete the updates I'm working on now. I am
assuming that all was running well for you with v4.0 prior to installing
the v4.1 beta. Is that correct?



Sam
------------------------------------------------------------------------
SamY's Profile: http://forums.slimdevices.com/member.php?userid=63495
View this thread: http://forums.slimdevices.com/showthread.php?t=60114

_______________________________________________
plugins mailing list
plugins@lists.slimdevices.com
http://lists.slimdevices.com/mailman/listinfo/plugins

Reply via email to