Tom Lane <[EMAIL PROTECTED]> writes:
> I was thinking GUC settings only; is there a real use-case for
> table-specific delay parameters? ISTM the point of the delay parameters
> for autovac is to put a lid on its impact on interactive response. Seen
> in that light, you do not care exactly which table it's hitting at the
> moment.
I'm not sure that's true.
ISTM if you have a small table that needs to be vacuumed frequently you
probably don't want it taking longer than necessary to vacuum. It's probably
mostly cached so there wouldn't be much of an i/o hit and even a small sleep
can make a big proportional difference in vacuum run time. You could get into
a situation where it takes longer to vacuum a bunch of such tables than the
frequency you need the vacuuming to taking place.
I think the i/o problem comes when you have large uncached tables. They
probably have a relatively small percentage of the table being updated and so
don't need to be vacuumed frequently. But when they do you need the sleeps to
avoid the i/o problems.
--
greg
---------------------------(end of broadcast)---------------------------
TIP 1: if posting/reading through Usenet, please send an appropriate
subscribe-nomail command to [EMAIL PROTECTED] so that your
message can get through to the mailing list cleanly
