On Thu, Jan 13, 2011 at 9:01 PM, Heikki Linnakangas <heikki.linnakan...@enterprisedb.com> wrote: > While testing Fujii-san's patch to flush any already-written WAL on error in > walreceiver, I added a debugging elog to XLogWalRcvFlush() to print out how > far it has written and flushed. > > I saw an unexpected pattern while the standby catches up with the master: > > LOG: streaming replication successfully connected to primary > LOG: flushing flush=0/0 write=0/1E020000 > LOG: flushing flush=0/1E020000 write=0/1E040000 > LOG: flushing flush=0/1E040000 write=0/1E060000 > LOG: flushing flush=0/1E060000 write=0/1E080000 > LOG: flushing flush=0/1E080000 write=0/1E0A0000 > LOG: flushing flush=0/1E0A0000 write=0/1E0C0000 > LOG: flushing flush=0/1E0C0000 write=0/1E0E0000 > LOG: flushing flush=0/1E0E0000 write=0/1E100000 > LOG: flushing flush=0/1E100000 write=0/1E120000 > LOG: flushing flush=0/1E120000 write=0/1E140000 > > The master sends the WAL at full-speed, but walreceiver always fsyncs it in > 128 kB chunks. That's excessive, it should be able to read and write to disk > the whole WAL segment before flushing. > > There's a little flaw in the walreceiver logic that tries to read all the > available WAL before flushing and sleeping. The way libpqrcv_receive is > written, when it's called with timeout==0 it will not call PQconsumeInput. > So what happens is that when walreceiver main loop calls libpqrcv_receive() > in a loop to fetch all WAL that's available without blocking, it actually > only reads the WAL that's in the libpq receive buffer - it will not read the > WAL that's in the TCP read buffer. > > Attached patch fixes libpqrcv_receive() so that it calls PQconsumeInput() > before concluding that there's no data available. The excessive fsyncing can > lead to very bad performance, so this needs to be appled to 9.0 too.
Seems good. Can we remove the "justconnected" flag, thanks to the patch? Regards, -- Fujii Masao NIPPON TELEGRAPH AND TELEPHONE CORPORATION NTT Open Source Software Center -- Sent via pgsql-hackers mailing list (pgsql-hackers@postgresql.org) To make changes to your subscription: http://www.postgresql.org/mailpref/pgsql-hackers
