Peter Eisentraut <[EMAIL PROTECTED]> writes:
> The determination of locale is now done as follows:
> initdb --lc-collate, initdb --locale, LC_ALL, LC_COLLATE, LANG
> initdb --no-locale is the same as initdb --locale=C, for convenience.
I'm confused; what is the default behavior if you don't give any
switches to initdb?
BTW, something that's been bothering me for awhile is that the notice
we stuck into the backend a couple versions back (about "this locale
disables LIKE optimizations") is being hidden by initdb, because you
decided recently that it was okay to route all the backend's commentary
to /dev/null so as to hide xlog.c's startup chattiness. I don't object
to getting rid of that chattiness, but 2>/dev/null is throwing the baby
out with the bathwater (consider outright failure messages, for instance).
It might be that Bruce's recent changes to elog levels allow a graceful
compromise about backend messages during initdb. I haven't looked, but
maybe initdb could run the backend with message level one notch higher
than LOG to suppress all the normal-case messages without masking not-
so-normal cases.
regards, tom lane
---------------------------(end of broadcast)---------------------------
TIP 2: you can get off all lists at once with the unregister command
(send "unregister YourEmailAddressHere" to [EMAIL PROTECTED])
