On 6/26/04 3:01 PM, "Keary Suska" <[EMAIL PROTECTED]> wrote:
>> I attempted to compile 7.4.3 with enable-thread-safety but it fails and >> says it's not supported. My configure command was: >> >> ./configure --enable-thread-safety > > This is what I did for 10.3.4/7.4.2: > > 1. Enabled thread support in the platform template: src/template/darwin (see > src/tools/thread/README for info) > > 2. Configured/compiled > > 3. Ran the thread_test program that was created by compile (in > src/tools/thread) > > 4. Followed any recommendations output by the program > > 5. Re-configured/compiled > > Everything was fine. You shouldn't have to mess with template/darwin. Back post 7.4.2 I went through a number of iterations with the developers on this and it was working out of the box. They were in the process of rewriting the threads detection and configuration to be more clean and reliable. I just tried it from the CVS source and it worked fine, even after a 'make clean'. However, when I download 7.4.3 and try it, I get the same error as you. The darwin template is identical between the two. I would have thought all those code changes would have been incorporated in 7.4.3. I think this requires some more investigation. Mac OS X 10.3.x should be working off the bat. Wes ---------------------------(end of broadcast)--------------------------- TIP 1: subscribe and unsubscribe commands go to [EMAIL PROTECTED]
