On 12/02/2015 12:40 PM, Mark Roberts wrote:
Matthew Hunt wrote:
On Thu, Feb 12, 2015 at 12:42 PM, P.J. Alling
<[email protected]> wrote:
I expect it was produced by the traditional clay modeling methods. Three D
printers are really only big in labs, and with geeks.
Dpreview says it's 3D-printed:
http://www.dpreview.com/articles/8579230519/cp-2015-up-close-and-personal-with-ricoh-full-frame-mockup?slide=2
My sense is that 3D printing is more prevalent than you describe.
It's pretty routine now. Even for smaller companies. I'd be surprised
if Pentax made prototype models any other way.
I'd be surprised if Ricoh wasn't making 3D printers.
bill
--
PDML Pentax-Discuss Mail List
[email protected]
http://pdml.net/mailman/listinfo/pdml_pdml.net
to UNSUBSCRIBE from the PDML, please visit the link directly above and follow
the directions.
