Hi Greg, Joel and all,

Thanks for your discussion on the MPLS mailing list as following link shown~
https://mailarchive.ietf.org/arch/msg/mpls/e3CI8xeDN1OTu5FgAIB6tI_yRaY/ 

Allow me to take the discussion to PCE. As per RFC9545 and 
draft-ietf-spring-srv6-path-segment, a path segment can identify a SR path, a 
SR policy,  a candidate-path or a SID-List in a SR policy. But this document 
did not mention the path segment processing within SR policy PCEP 
instantiation. It may cause some misunderstandings about PCEP processes and 
parameters for path segment within a SR policy.  So I suggest to add some texts 
for next version of this draft.  Please see inline with <suggested text>.


  1 Introduction     [RFC8664] specifies extensions to the Path Computation 
Element
   Protocol (PCEP) [RFC5440] for SR networks, that allow a stateful PCE
   to compute and initiate SR-TE paths, as well as a PCC to request,
   report or delegate SR paths. <suggested text> 
"[ietf-pce-segment-routing-policy-cp]
   specifies the PCEP extension to signal candidate paths of the SR Policy. "   
   This document specifies a mechanism to carry the SR path
   identification information in PCEP messages [RFC5440] [RFC8231]
   [RFC8281].  The SR path identifier can be a Path Segment in SR-MPLS
   [RFC9545] and SRv6 [I-D.ietf-spring-srv6-path-segment], or other IDs
   that can identify an SR path <suggested  text> "or an SR Policy".  This 
document also extends the PCECC-
   SR mechanism to inform the Path Segment to the egress PCC.               
5.1.1 Ingress PCC-Initiated Path Segment Allocation      The PATH-SEGMENT TLV 
MUST be included in an LSP object in the
   PCInitiate message sent from the PCE to the egress to request Path
   Segment allocation by the egress PCC.  The P flag in LSP object MUST
   be set to 0.  This PCInitiate message to egress PCC would be the
   similar to the one sent to ingress PCC as per [RFC8664], but the
   egress PCC would only allocate the Path Segment and would not trigger
   the LSP initiation operation (as it would be the egress for this
   LSP). <suggested  text> "The association object should also be carried in 
PCInitiate message
   to indicate the SR policy association parameters  as per 
[ietf-pce-segment-routing-policy-cp] 
   if this path segment identifies an SR policy."   
What is your thoughts with these texts? Thanks!

Best Regards,
Quan




<<[Pce] I-D Action: draft-ietf-pce-sr-path-segment-10.txt
internet-dra...@ietf.org Wed, 28 August 2024 13:56 UTCShow header
Internet-Draft draft-ietf-pce-sr-path-segment-10.txt is now available. It is a
work item of the Path Computation Element (PCE) WG of the IETF.

 Title: Path Computation Element Communication Protocol (PCEP) Extension for 
Path Segment in Segment Routing (SR)
 Authors: Cheng Li
 Mach(Guoyi) Chen
 Weiqiang Cheng
 Rakesh Gandhi
 Quan Xiong
 Name: draft-ietf-pce-sr-path-segment-10.txt
 Pages: 25
 Dates: 2024-08-28

Abstract:

 The Path Computation Element (PCE) provides path computation
 functions in support of traffic engineering in Multiprotocol Label
 Switching (MPLS) and Generalized MPLS (GMPLS) networks.

 The Source Packet Routing in Networking (SPRING) architecture
 describes how Segment Routing (SR) can be used to steer packets
 through an IPv6 or MPLS network using the source routing paradigm. A
 Segment Routed Path can be derived from a variety of mechanisms,
 including an IGP Shortest Path Tree (SPT), explicit configuration, or
 a Path Computation Element (PCE).

 Path identification is needed for several use cases such as
 performance measurement in Segment Routing (SR) network. This
 document specifies extensions to the Path Computation Element
 Communication Protocol (PCEP) to support requesting, replying,
 reporting and updating the Path Segment ID (Path SID) between PCEP
 speakers.

The IETF datatracker status page for this Internet-Draft 
is:https://datatracker.ietf.org/doc/draft-ietf-pce-sr-path-segment/There is 
also an HTMLized version available 
at:https://datatracker.ietf.org/doc/html/draft-ietf-pce-sr-path-segment-10A 
diff from the previous version is available 
at:https://author-tools.ietf.org/iddiff?url2=draft-ietf-pce-sr-path-segment-10Internet-Drafts
 are also available by rsync at:
rsync.ietf.org::internet-drafts

[Pce] I-D Action: draft-ietf-pce-sr-path-segment-…  internet-drafts
_______________________________________________
Pce mailing list -- pce@ietf.org
To unsubscribe send an email to pce-le...@ietf.org

Reply via email to