The other possible choice is that you may have gone into your sound card settings and changed a setting which may produce a mono signal. For example I've got a SB audigy 2 card here and in the audio HQ in control pannel there are several different choices. I chose 5.1 surround sound because that's the kind of system I have.
So I would check in the control pannel and look for a place where you can make changes to your sound card.
At 05:22 PM 3/14/2005, you wrote:
There two possible problems assuming the speaker cables are good and properly connected.
1: in volume controls, under properties, you may have checked the mute for stereo mixer but not for mono. Second, in the audio settings for speaker set up, you may have the wrong speaker choice checked. The crystal drivers are on the disk used to install your mother board. If you have that disk and insert it, it should bring up a menu which includes "audio." You may need a pair of functioning eyes present for that one, I really don't remember whether it speaks or not.
RD
_______________________________________________ PC-Audio List Help, Guidelines, Archives and more... http://www.pc-audio.org
To unsubscribe from this list, send a blank email to: [EMAIL PROTECTED]
_______________________________________________
PC-Audio List Help, Guidelines, Archives and more... http://www.pc-audio.org
To unsubscribe from this list, send a blank email to: [EMAIL PROTECTED]
