Hi,
There is a thick plastic label on the bottom. It has one corner cutoff. One can take a screwdriver and very gently peal the label about half way back. Underneath are three holes. The pot that you want to adjust is inside the largest of the three. Turn it gently as far as it will go to the right. Be very careful as this pot is easily broken. This will increase the power of the transmitter. Once this has been done, the label can be put back in place.
Robert Carter
At 11:43 AM 5/8/2004, you wrote:
Hi folks! Well, I purchased the transmitter from Ccrane, and it seems to be working well. Someone had a tip on the list about making the signal a little stronger, and I deleted the message, by mistake. There is a screw somewhere on the transmitter that you're supposed to turn. Where do you find that screw?
_______________________________________________
PC-Audio List Help, Guidelines, Archives and more...
http://www.pc-audio.org
To unsubscribe from this list, send a blank email to: [EMAIL PROTECTED]
_______________________________________________
PC-Audio List Help, Guidelines, Archives and more... http://www.pc-audio.org
To unsubscribe from this list, send a blank email to: [EMAIL PROTECTED]
