Hmm. I cannot find that property either by searching or by visual inspection. Perhaps its only in a newer version of Paraview? I am using 4.3.1
Rao On 02/05/16 12:56, Moreland, Kenneth wrote: > Rao, > > I think you were asking how to get the file ID representing the > processor holding the piece in the simulation whereas Andy's > instructions tell you the process ID that the parts got loaded into > the visualization. > > To get the file ID, go to the properties panel for the Exodus reader > and find the property labeled "Generate File Id Array." (The easiest > way to find it is to type "generate" in the search bar at the top of > the properties panel.) Turn on that checkbox and ParaView will > generate a field named "FileId". Just color by that field and you are > good to go. > > -Ken > > From: ParaView <[email protected] > <mailto:[email protected]>> on behalf of Andy Bauer > <[email protected] <mailto:[email protected]>> > Date: Friday, February 5, 2016 at 12:27 PM > To: "Garimella, Rao Veerabhadra (LANL)" <[email protected] > <mailto:[email protected]>> > Cc: "[email protected] <mailto:[email protected]>" > <[email protected] <mailto:[email protected]>> > Subject: [EXTERNAL] Re: [Paraview] Coloring parallel Exodus II meshes > by file/Processor ID > > HI Rao, > > The Process Id Scalars creates a field that shows the current > partitioning of the grid for pvserver. That may be what you're looking > for. If you're looking for the grid partitioning that was used for the > simulation, this information would need to be communicated in the > ExodusII file itself. Depending on how things are written out, there > should be a block ID available though that you give you this > information for certain simulation outputs. > > Please let me know if this isn't what you're looking for and we can > try and see how to get it. > > Best, > Andy > > On Fri, Feb 5, 2016 at 12:33 PM, Rao Garimella <[email protected] > <mailto:[email protected]>> wrote: > > Hi > > I tried looking for this in the archives but did not find anything > relevant. > > After importing a distributed mesh from the Exodus II/Nemesis I format > into paraview, how can I ask it to color the elements based on the > file/processor ID that they were read in from? > > Thanks > Rao > _______________________________________________ > Powered by www.kitware.com <http://www.kitware.com> > > Visit other Kitware open-source projects at > http://www.kitware.com/opensource/opensource.html > <http://www.kitware.com/opensource/opensource.html> > > Please keep messages on-topic and check the ParaView Wiki at: > http://paraview.org/Wiki/ParaView <http://paraview.org/Wiki/ParaView> > > Search the list archives at: > http://markmail.org/search/?q=ParaView > <http://markmail.org/search/?q=ParaView> > > Follow this link to subscribe/unsubscribe: > http://public.kitware.com/mailman/listinfo/paraview > >
_______________________________________________ Powered by www.kitware.com Visit other Kitware open-source projects at http://www.kitware.com/opensource/opensource.html Please keep messages on-topic and check the ParaView Wiki at: http://paraview.org/Wiki/ParaView Search the list archives at: http://markmail.org/search/?q=ParaView Follow this link to subscribe/unsubscribe: http://public.kitware.com/mailman/listinfo/paraview
