Hi James, On Tue, 1 Oct 2013 10:00:06 -0700 (PDT) James Oakley <jf...@funktronics.ca> wrote: > > I don't know, but my configuration is - as said - almost similar, > > but a > > _lot_ shorter, due to usage of groups and thus far less contraints > > and > > location definitions. My nodes are virtual machines in VMware, thus > > the > > vcenter stonith resources. The nodes, hermes1 and hermes 2 have the > > drbd resources, hermes1 being the preferred node, and hermes3 is > > there for quorum (and logs): > > It seems that drbd slaves are working OK for you. My problem is that > Pacemaker will only run the master part. It will happily attempt to > run the master on either of the DRBD nodes (and the non-DRBD node...) > but it flat out refuses to run the slave. It doesn't even try, and it > will actually shut down the secondary DRBD configuration if I bring > it up manually. I can't find a single log message to indicate why, > and I can't find a command or configuration option to say "run this > slave on this node."
OK, but my primary intention was to give you a working example configuration quite similar to yours, which you can compare. I suspect, that your constraints do not allow the slaves being activated. I suggest you try to start with a smaller configuration without locations and constraints, perhaps groups, and start adding constraints. Start with the drbd resources, add order and colocations. Greetings, Stefan -- Stefan Botter zu Hause Bremen _______________________________________________ Pacemaker mailing list: Pacemaker@oss.clusterlabs.org http://oss.clusterlabs.org/mailman/listinfo/pacemaker Project Home: http://www.clusterlabs.org Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf Bugs: http://bugs.clusterlabs.org
