on 03/22/2012 12:56 AM Aaron Z wrote the following: > Aggelos Manousidis <[email protected]> wrote: >> I had installed about a year ago some version of kamikaze (I think it >> was 8.09.1) on the WRT54GL. >> I don't recall what settings I had set, like the IP address/port the >> web interface would listen on. > <SNIP/> >> So my question is, how can I recover from that situation? > > Here is what I do when mass flashing WRT54GLs: > 1. Turn it off > 2. Set your IP computer address to 192.168.1.3 (mask 255.255.255.0) > 3. Turn it back on > 4. As soon as the DMZ light comes on, press and hold either the "Secure Easy > Setup" button or the Reset button until the DMZ light starts to blink > 5. Telnet to 192.168.1.1
I think I tried that and it didn't respond even to ping of 192.168.1.1. I' ll try again and see. Should I try to connect (telnet) from one of the four lan (ethernet) ports of the WRT54GL, or from the WAN ethernet side? > 6a. If you dont care about keeping the existing config, run the "firstboot" > command (without the quotes) then reboot That's what I'll do, if I can make it and telnet into it ... > 6b. If you want to keep the config, see > http://wiki.openwrt.org/doc/howto/generic.failsafe#in.failsafe.mode for how > to unlock the config files I don't want to keep the config. I just want to gain back control of the router (WRT54GL). _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-users
