Milan P. Stanic wrote: > Hello, > > After upgrade to Kamikaze 8.09 bridge stopped to work with my two > Linksys WRT54GL as it should. Both of them worked in version 7.09. > > My test setup is depicted here: > Wireless > /---------/\/\/\-----------\ > | | > +----------+ +------+----+ +--+-------+ > | switch | | wrt54gl | | notebook | > +-+--+-----+ +----+------+ +----------+ > | | | > | \_________________/ > | Ether cable > | > \__________________________ > other equipment on the net > > > /etc/config/network > ------------------------------------------- > #### VLAN configuration > config switch eth0 > option vlan0 "0 1 2 3 5*" > option vlan1 "4 5" > > > #### Loopback configuration > config interface loopback > option ifname "lo" > option proto static > option ipaddr 127.0.0.1 > option netmask 255.0.0.0 > > > #### LAN configuration > config interface lan > option type bridge > option ifname "eth0.0" > option proto static > option ipaddr 10.5.1.2 > option netmask 255.255.255.0 > > > #### WAN configuration > config interface wan > option ifname "eth0.1" > option proto dhcp > > > /etc/config/wireless > ------------------------------------------- > config wifi-device wlan0 > option type mac80211 > option channel 1 > > config wifi-iface > option device wlan0 > option network lan > option mode ap > option ssid test > option encryption none > > > When the Ethernet cable is *not* connected to any of the Ethernet ports > on the router wifi works fine and I can ping and ssh to the router > without problem. > > But, when I connect Ethernet cable in any of the ports on switch the > traffic stops immediately and I can't ping router anymore or anything > behind it on the network. > > When I disconnect cable the wifi continues to work and I can ping the > router and ssh into without problems. > > I tried to stop firewall (iptables shows empty all tables) without any > benefit. Also tried both versions (brcm47xx and brcm-2.4) but with the > same results. Also tried to build development version from svn but > again, results are same. > > Any help would be appreciated. >
If you downgrade now does it still happen? Sound like the hardware has gone funky. _______________________________________________ openwrt-users mailing list [email protected] https://lists.openwrt.org/mailman/listinfo/openwrt-users
