I have been using an older version of OpenWRT on my E110Ns; I loaded up the latest release to see if it would fix some "LOST BEACON" problems.
Unfortunately, it didn't even boot (went into a bootloop), so I broke out the serial cable, busted open the radio, and connected it. Here's what I captured: <code> U-Boot 1.1.4-ge619c187-dirty (Apr 12 2017 - 18:52:08) ap143 - Honey Bee 2.0 DRAM: 64 MB Flash: 16 MB dup 1 speed 100 Using eth0 device ping failed; host 192.168.1.10 is not alive Unknown command 'ERROR!' - try 'help' Hit any key to stop autoboot: 1 0 ## Booting image at 9f020000 ... Image Name: MIPS OpenWrt Linux-5.15.134 Created: 2023-10-09 21:45:35 UTC Image Type: MIPS Linux Kernel Image (lzma compressed) Data Size: 2328775 Bytes = 2.2 MB Load Address: 80060000 Entry Point: 80060000 Verifying Checksum at 0x9f020040 ...OK Uncompressing Kernel Image ... OK No initrd ## Transferring control to Linux (at address 80060000) ... ## Giving linux memsize in bytes, 67108864 Starting kernel ... [ 0.000000] Linux version 5.15.134 (builder@buildhost) (mips-openwrt-linux-musl-gcc (OpenWrt GCC 12.3.0 r23497-6637af95aa) 12.3.0, GNU ld (GNU Binutils) 2.40.0) #0 Mon Oct 9 21:45:35 2023 [ 0.000000] printk: bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc) [ 0.000000] MIPS: machine is COMFAST CF-E110N v2 [ 0.000000] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0 [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 16240 [ 0.000000] Kernel command line: console=ttyS0,115200n8 rootfstype=squashfs,jffs2 [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes, linear) [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes, linear) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] mem auto-init: stack:off, heap alloc:off, heap free:off [ 0.000000] Memory: 55972K/65536K available (6077K kernel code, 591K rwdata, 780K rodata, 1184K init, 217K bss, 9564K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS: 51 [ 0.000000] CPU clock: 650.000 MHz [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5880801374 ns [ 0.000002] sched_clock: 32 bits at 325MHz, resolution 3ns, wraps every 6607641598ns [ 0.008370] Calibrating delay loop... 432.53 BogoMIPS (lpj=2162688) [ 0.074950] pid_max: default: 32768 minimum: 301 [ 0.080919] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes, linear) [ 0.088644] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes, linear) [ 0.105660] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.116125] futex hash table entries: 256 (order: -1, 3072 bytes, linear) [ 0.123566] pinctrl core: initialized pinctrl subsystem [ 0.131441] NET: Registered PF_NETLINK/PF_ROUTE protocol family [ 0.138492] thermal_sys: Registered thermal governor 'step_wise' [ 0.153766] clocksource: Switched to clocksource MIPS [ 0.167301] NET: Registered PF_INET protocol family [ 0.172759] IP idents hash table entries: 2048 (order: 2, 16384 bytes, linear) [ 0.181676] tcp_listen_portaddr_hash hash table entries: 512 (order: 0, 4096 bytes, linear) [ 0.190630] Table-perturb hash table entries: 65536 (order: 6, 262144 bytes, linear) [ 0.198823] TCP established hash table entries: 1024 (order: 0, 4096 bytes, linear) [ 0.206939] TCP bind hash table entries: 1024 (order: 0, 4096 bytes, linear) [ 0.214408] TCP: Hash tables configured (established 1024 bind 1024) [ 0.221345] UDP hash table entries: 256 (order: 0, 4096 bytes, linear) [ 0.228344] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes, linear) [ 0.236302] NET: Registered PF_UNIX/PF_LOCAL protocol family [ 0.242338] PCI: CLS 0 bytes, default 32 [ 0.251473] workingset: timestamp_bits=14 max_order=14 bucket_order=0 [ 0.264981] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.271158] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.283297] Block layer SCSI generic (bsg) driver version 0.4 loaded (major 251) [ 0.296681] pinctrl-single 1804002c.pinmux: 576 pins, size 72 [ 0.304425] Serial: 8250/16550 driver, 16 ports, IRQ sharing enabled [ 0.314714] printk: console [ttyS0] disabled [ 0.319327] 18020000.uart: ttyS0 at MMIO 0x18020000 (irq = 9, base_baud = 1562500) is a 16550A [ 0.328537] printk: console [ttyS0] enabled [ 0.328537] printk: console [ttyS0] enabled [ 0.337608] printk: bootconsole [early0] disabled [ 0.337608] printk: bootconsole [early0] disabled [ 0.373725] spi-nor spi0.0: w25q128 (16384 Kbytes) [ 0.378894] 4 fixed-partitions partitions found on MTD device spi0.0 [ 0.385536] OF: Bad cell count for /ahb/spi@1f000000/flash@0/partitions [ 0.392416] OF: Bad cell count for /ahb/spi@1f000000/flash@0/partitions [ 0.400124] OF: Bad cell count for /ahb/spi@1f000000/flash@0/partitions [ 0.407094] OF: Bad cell count for /ahb/spi@1f000000/flash@0/partitions [ 0.414211] Creating 4 MTD partitions on "spi0.0": [ 0.419186] 0x000000000000-0x000000010000 : "u-boot" [ 0.432380] 0x000000010000-0x000000020000 : "art" [ 0.438974] 0x000000020000-0x000000ff0000 : "firmware" [ 0.448501] 2 uimage-fw partitions found on MTD device firmware [ 0.454736] Creating 2 MTD partitions on "firmware": [ 0.459874] 0x000000000000-0x000000240000 : "kernel" [ 0.466527] 0x000000240000-0x000000fd0000 : "rootfs" [ 0.475397] mtd: setting mtd4 (rootfs) as root device [ 0.480780] 1 squashfs-split partitions found on MTD device rootfs [ 0.487281] 0x0000005b0000-0x000000fd0000 : "rootfs_data" [ 0.495748] 0x000000ff0000-0x000001000000 : "nvram" [ 0.914866] ag71xx 19000000.eth: Could not connect to PHY device. Deferring probe. </code> (reboot) Is anyone else using the CF-110N? -Bill _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
