This adds the lan/wan default bridge config and also the MAC
NVRAM read-out for et2.
DIR-885L was missing a default bridge config so I just added
that too while I was at it.
Signed-off-by: Linus Walleij <linus.wall...@linaro.org>
---
ChangeLog v1->v2:
- The DIR-890L sets up the Mac address from the NVRAM
indicated in the device tree so drop that oneliner.
---
target/linux/bcm53xx/base-files/etc/board.d/02_network | 4 ++++
1 file changed, 4 insertions(+)
diff --git a/target/linux/bcm53xx/base-files/etc/board.d/02_network
b/target/linux/bcm53xx/base-files/etc/board.d/02_network
index 6bec600540ea..ba1cf7ac8d94 100644
--- a/target/linux/bcm53xx/base-files/etc/board.d/02_network
+++ b/target/linux/bcm53xx/base-files/etc/board.d/02_network
@@ -16,6 +16,10 @@ bcm53xx_setup_interfaces()
asus,rt-ac88u)
ucidef_set_interfaces_lan_wan "lan1 lan2 lan3 lan4 extsw" "wan"
;;
+ dlink,dir-885l | \
+ dlink,dir-890l)
+ ucidef_set_interfaces_lan_wan "lan1 lan2 lan3 lan4" "wan"
+ ;;
dlink,dwl-8610ap)
ucidef_set_interface_lan "eth0 eth1" "dhcp"
;;
--
2.34.1
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
