On 10/10/21 2:44 AM, Sergey Ryazanov wrote:
Hello Rui,
On Fri, Oct 8, 2021 at 4:40 PM Rui Salvaterra <rsalvate...@gmail.com> wrote:
On Fri, 8 Oct 2021 at 11:09, Rui Salvaterra <rsalvate...@gmail.com> wrote:
Nothing in this target has more than 32 MiB of RAM (most devices have
16 MiB) [1]. Just put it out of its misery. :)
Scratch that. After chatting with dangole, there may be some life in
it, after all. I have an ath25 device (FON2200) and didn't even
remember it.
I am in the process of migrating ath25 to the 5.10 kernel. Initial
build was trivial. But I need to restore the Marvel swconfig driver
that was lost during the initial 5.10 kernel introduction, and
carefully run-time test it.
Hi,
Does it make sense to directly convert this board to the upstream DSA
driver for the Marvell 88E6060 switch:
https://elixir.bootlin.com/linux/v5.10.72/source/drivers/net/dsa/mv88e6060.c
It looks like our swconfig driver creates a bridge over all ports and
the DSA driver only allows communication between the individual port and
the CPU port.
I do not know how much effort this is and if you have the device for
testing.
Hauke
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
