On Thu, May 27, 2021 at 11:18 AM Denis Kalashnikov <denis281...@gmail.com> wrote: > From: Denis Kalashnikov <denis281...@gmail.com> > > This board has been supported in the ar71xx. > > Links: > * https://mikrotik.com/product/RB912UAG-2HPnD > * https://openwrt.org/toh/hwdata/mikrotik/mikrotik_rb912uag-2hpnd > > Hardware: > * SoC: Atheros AR9342, > * RAM: DDR 64MB, > * SPI NOR: 64KB, > * NAND: 128MB, > * Ethernet: x1 10/100/1000 port with passive POE in, > * Wi-Fi: 802.11 b/g/n, > * PCIe, > * USB: 2.0 EHCI controller, connected to mPCIe slot and a Type-A > port -- both can be used for LTE modem. But only one can be used. > * LEDs: 5 general purpose LEDs (led1..led5), power LED, user LED, > Ethernet phy LED, > * Button, > * Beeper. > > Not working: > * Button: it shares gpio line 15 with NAND ALE and NAND IO7, > and current drivers doesn't easily support this configuration, > * Beeper: it is connected to bit 5 of a serial shift register > (tested with sysfs led trigger timer). But kmod-gpio-beeper > doesn't work -- we left this as is for now. > > Flashing: > * Use the RouterBOARD Reset button to enable TFTP netboot, > boot kernel and initramfs and then perform sysupgrade. > * From ar71xx OpenWrt firmware run: > $ sysupgrade -F /tmp/<sysupgrade.bin> > For more info see: https://openwrt.org/toh/mikrotik/common. > > Co-Developed-by: Koen Vandeputte <koen.vandepu...@citymesh.com> > Signed-off-by: Denis Kalashnikov <denis281...@gmail.com>
Reviewed-by: Sergey Ryazanov <ryazanov....@gmail.com> _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
