The sender domain has a DMARC Reject/Quarantine policy which disallows
sending mailing list messages using the original "From" header.

To mitigate this problem, the original message has been wrapped
automatically by the mailing list software.
--- Begin Message ---
Hi Joe,

El 13/6/20 a les 21:00, Joe Ayers ha escrit:
> Anyone else seeing this on recently purchased  Mikrotik models?
> Installing openwrt 19.07.03 on a Mikrotik LHG 5 boots, initfs and
> appears to succeed with sysupgrade.  Then the device is in an infinite
> boot loop.   It appears there's no console configured in routerboot to
> see what it is doing.  Any pointers to turn on?
Is it the same with 19.07.2 or 19.07.1? Just to make sure it's not a
regression in OpenWrt.
> Note, I'm working with another individual seeing this on a new LHG 5
> model device.  I have reproduced and tested on a newly purchased SXTsq
> 5HPnD, which has a motherboard labeled "LHG 5HPnD".   Prior SXTsq
> 5HPnD  and LHG 5HPnD models  have been working fine.

When you boot via TFTP, can you check whether the dmesg lines "Kernel
command line" are the same on older and newer devices?

> sysupgrade log:
>
> Commencing upgrade. Closing all shell sessions.
> Watchdog handover: fd=3
> - watchdog -
> Sending TERM to remaining processes ... crond uhttpd xinetd sh dnsmasq
> sh ntpd netifd hostapd [  146.589174] device wlan0 left promiscuouse
> [  146.593957] br-lan: port 2(wlan0) entered disabled state
> sleep sleep ubusd urngd logd rpcd
> Sending KILL to remaining processes ...
> /lib/upgrade/stage2: line 126: [-x: not found

This last line does not look good, but I can't locate it in the source
code :(

Cheers!

> Performing system upgrade...
> Unlocking firmware ...
>
> Writing from <stdin> to firmware ...
> Upgrade completed
> Rebooting system...
> umount: can't unmount /dev: Resource busy
> umount: can't unmount /tmp: Resource busy
> umount: can't unmount /: Invalid argument
> [  185.682795] Removing MTD device #1 (hard_config) with use count 1
> [  185.690133] reboot: Restarting system
>
> regards,
> Joe AE6XE
>
> _______________________________________________
> openwrt-devel mailing list
> openwrt-devel@lists.openwrt.org
> https://lists.openwrt.org/mailman/listinfo/openwrt-devel



--- End Message ---
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel

Reply via email to