This series adds support for the D-Link DAP-2695-A1 to the ath79 target. Also available in the ath79_dap-2695-a1 branch of my staging tree at [0].
Successfully tested sysupgrade from ar71xx to ath79. As discussed on IRC, I prefer to keep the network setup identical to ar71xx, so this wasn't changed. Changes since v1: * Drop the commit that put D-Link images definitions in a separate file, to focus on getting support for the device in order rather than wasting time over something cosmetic. * Drop default-state = "off" from leds, set default-state = "on" for power LED, add aliases indicating boot, failsafe and upgrade, add linux,default-trigger = "phy1tpt" to wlan2g. * Rename wifi_2g node to be consistent with the label. * Use gpio-keys instead of gpio-keys-polled. * Rename button node to reset. * Add newline before partitions node. * Drop uboot label. * Drop board from /etc/board.d/01_leds. * Add ath10k-ct and firmware to DEFAULT_PACKAGES. [0] https://git.openwrt.org/?p=openwrt/staging/stintel.git;a=summary Stijn Tintel (3): mtd: enable wrgg support for ath79 ath79: enable wrgg MTD splitter ath79: add support for D-Link DAP-2695-A1 package/system/mtd/src/Makefile | 2 +- target/linux/ath79/config-4.19 | 1 + target/linux/ath79/config-5.4 | 1 + .../ath79/dts/qca9558_dlink_dap-2695-a1.dts | 178 ++++++++++++++++++ .../generic/base-files/etc/board.d/02_network | 6 + .../etc/hotplug.d/firmware/10-ath9k-eeprom | 4 + .../etc/hotplug.d/firmware/11-ath10k-caldata | 4 + .../etc/uci-defaults/09_fix-checksum | 8 + .../base-files/lib/preinit/10_fix_eth_mac.sh | 4 + target/linux/ath79/image/generic.mk | 33 ++++ 10 files changed, 240 insertions(+), 1 deletion(-) create mode 100644 target/linux/ath79/dts/qca9558_dlink_dap-2695-a1.dts -- 2.26.2 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
