At http:\\arednmesh.org, we've had several mikrotik devices working, all with "LHG" motherboards. One of the devices, RB LHG 2nD-XL no longer boots with upgrade from 18.06.2 to 19.07.0. Other devices with same "LHG" mother board continue to work fine, e.g. RB LHG 5nD-XL, LHG 5nDHP.
I'm stuck on getting this working, if you have any pointers, please let me know. Here's dmesg where it hangs: [ 0.000000] Linux version 4.14.162 (joe@AE6XE-VM) (gcc version 7.5.0 (OpenWrt GCC 7.5.0 r10860-a3ffeb413b)) #0 Mon Jan 6 16:47:09 2020 [ 0.000000] bootconsole [early0] enabled [ 0.000000] CPU0 revision is: 00019374 (MIPS 24Kc) [ 0.000000] SoC: Qualcomm Atheros QCA9533 ver 2 rev 0 [ 0.000000] Determined physical RAM map: [ 0.000000] memory: 04000000 @ 00000000 (usable) [ 0.000000] User-defined physical RAM map: [ 0.000000] memory: 04000000 @ 00000000 (usable) [ 0.000000] Initrd not found or empty - disabling initrd [ 0.000000] Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes. [ 0.000000] Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes [ 0.000000] Zone ranges: [ 0.000000] Normal [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] Movable zone start for each node [ 0.000000] Early memory node ranges [ 0.000000] node 0: [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] Initmem setup node 0 [mem 0x0000000000000000-0x0000000003ffffff] [ 0.000000] random: get_random_bytes called from 0x80477740 with crng_init=0 [ 0.000000] Built 1 zonelists, mobility grouping on. Total pages: 16256 [ 0.000000] Kernel command line: no-uart no-buzzer no-nand parts=1 boot_part_size=16777216 gpio=0 HZ=325000000 mem=64M kmac=B8:69:F4:79:52:22 board=lhg-hb board=lhg-hb ver=6.42 hw_opt=00284001 boot=1 mlc=11 console=ttyS0,115200 rootfstype=squashfs noinitrd [ 0.000000] PID hash table entries: 256 (order: -2, 1024 bytes) [ 0.000000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.000000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.000000] Writing ErrCtl register=00000000 [ 0.000000] Readback ErrCtl register=00000000 [ 0.000000] Memory: 59928K/65536K available (3634K kernel code, 162K rwdata, 384K rodata, 228K init, 198K bss, 5608K reserved, 0K cma-reserved) [ 0.000000] SLUB: HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 [ 0.000000] NR_IRQS: 51 [ 0.000000] Clocks: CPU:650.000MHz, DDR:600.000MHz, AHB:300.000MHz, Ref:25.000MHz [ 0.000000] clocksource: MIPS: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 5880801374 ns [ 0.000009] sched_clock: 32 bits at 325MHz, resolution 3ns, wraps every 6607641598ns [ 0.008858] Calibrating delay loop... 432.53 BogoMIPS (lpj=2162688) [ 0.075986] pid_max: default: 32768 minimum: 301 [ 0.081432] Mount-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.088943] Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.099268] clocksource: jiffies: mask: 0xffffffff max_cycles: 0xffffffff, max_idle_ns: 19112604462750000 ns [ 0.110476] futex hash table entries: 256 (order: -1, 3072 bytes) [ 0.117873] NET: Registered protocol family 16 [ 0.126436] MIPS: machine is MikroTik RouterBOARD LHG 2nD-XL [ 0.133043] ar71xx: invalid MDIO id 1 [ 0.385180] clocksource: Switched to clocksource MIPS [ 0.391886] NET: Registered protocol family 2 [ 0.397634] TCP established hash table entries: 1024 (order: 0, 4096 bytes) [ 0.405608] TCP bind hash table entries: 1024 (order: 0, 4096 bytes) [ 0.412831] TCP: Hash tables configured (established 1024 bind 1024) [ 0.420200] UDP hash table entries: 256 (order: 0, 4096 bytes) [ 0.426879] UDP-Lite hash table entries: 256 (order: 0, 4096 bytes) [ 0.434266] NET: Registered protocol family 1 [ 0.444824] workingset: timestamp_bits=30 max_order=14 bucket_order=0 [ 0.457143] squashfs: version 4.0 (2009/01/31) Phillip Lougher [ 0.463756] jffs2: version 2.2 (NAND) (SUMMARY) (LZMA) (RTIME) (CMODE_PRIORITY) (c) 2001-2006 Red Hat, Inc. [ 0.484675] io scheduler noop registered [ 0.489176] io scheduler deadline registered (default) [ 0.495371] Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled [ 0.502913] console [ttyS0] disabled [ 0.527117] serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11, base_baud = 1562500) is a 16550A [ 0.536918] console [ttyS0] enabled [ 0.536918] console [ttyS0] enabled [ 0.544460] bootconsole [early0] disabled [ 0.544460] bootconsole [early0] disabled [ 0.556787] m25p80 spi0.0: found w25q128jv, expected m25p80 [ 0.572223] m25p80 spi0.0: w25q128jv (16384 Kbytes) [ 0.577745] Creating 6 MTD partitions on "spi0.0": [ 0.582708] 0x000000000000-0x00000000e000 : "routerboot" [ 0.589854] 0x00000000e000-0x00000000f000 : "hard_config" [ 0.596836] 0x00000000f000-0x000000010000 : "bios" [ 0.603684] 0x000000010000-0x00000001f000 : "routerboot2" [ 0.610655] 0x00000001f000-0x000000020000 : "soft_config" [ 0.618205] 0x000000020000-0x000001000000 : "firmware" [ 0.624569] 2 minor-fw partitions found on MTD device firmware [ 0.630670] 0x000000020000-0x000000190000 : "kernel" [ 0.636507] 0x000000190000-0x000001000000 : "rootfs" [ 0.642258] mtd: device 7 (rootfs) set to be root filesystem [ 0.648186] 1 squashfs-split partitions found on MTD device rootfs [ 0.654578] 0x0000006f0000-0x000001000000 : "rootfs_data" [ 0.664200] libphy: Fixed MDIO Bus: probed [ 0.690987] libphy: ag71xx_mdio: probed [ 1.327500] ag71xx-mdio.1: Found an AR934X built-in switch [ 1.380907] eth0: Atheros AG71xx at 0xba000000, irq 5, mode: gmii [ 1.388695] NET: Registered protocol family 17 [ 1.393352] 8021q: 802.1Q VLAN Support v1.8 [ 1.410019] VFS: Mounted root (squashfs filesystem) readonly on device 31:7. [ 1.418636] Freeing unused kernel memory: 228K [ 1.423222] This architecture does not have kernel memory protection. [ 2.026942] init: Console is alive [ 2.030709] init: - watchdog - [ 2.445217] random: fast init done [ 3.102742] kmodloader: loading kernel modules from /etc/modules-boot.d/* [ 3.154160] usbcore: registered new interface driver usbfs [ 3.159975] usbcore: registered new interface driver hub [ 3.165584] usbcore: registered new device driver usb [ 3.176012] ehci_hcd: USB 2.0 'Enhanced' Host Controller (EHCI) Driver [ 3.183571] kmodloader: done loading kernel modules from /etc/modules-boot.d/* [ 3.193344] init: - preinit - [ 3.630728] random: procd: uninitialized urandom read (4 bytes read) Press the [f] key and hit [enter] to enter failsafe mode Press the [1], [2], [3] or [4] key and hit [enter] to select the debug level [ 6.266613] eth0: link up (1000Mbps/Full duplex) It hangs at this point. What should occur, but does not (from 18.06.2): [ 7.632244] jffs2: notice: (354) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found. [ 7.649615] mount_root: switching to jffs2 overlay [ 7.687438] urandom-seed: Seeding with /etc/urandom.seed [ 7.841353] eth0: link down [ 7.855127] procd: - early - [ 7.858915] procd: - watchdog - [ 8.436062] procd: - watchdog - [ 8.440039] procd: - ubus - [ 8.632931] random: ubusd: uninitialized urandom read (4 bytes read) [ 8.643930] random: ubusd: uninitialized urandom read (4 bytes read) [ 8.651001] random: ubusd: uninitialized urandom read (4 bytes read) [ 8.658593] procd: - init - Please press Enter to activate this console. [ 9.049497] kmodloader: loading kernel modules from /etc/modules.d/* [ 9.061251] ipip: IPv4 and MPLS over IPv4 tunneling driver [ 9.089565] Loading modules backported from Linux version wt-2017-11-01-0-gfe248fc2c180 [ 9.097904] Backport generated by backports.git v4.14-rc2-1-31-g86cf0e5d [ 9.119572] nf_conntrack version 0.5.0 (1024 buckets, 4096 max) [ 9.293129] xt_time: kernel timezone is -0000 [ 9.447984] ip_tables: (C) 2000-2006 Netfilter Core Team [ 9.629677] ieee80211 phy0: Atheros AR9531 Rev:2 mem=0xb8100000, irq=47 [ 9.722604] kmodloader: done loading kernel modules from /etc/modules.d/* [ 10.709017] urandom_read: 5 callbacks suppressed [ 10.709024] random: jshn: uninitialized urandom read (4 bytes read) [ 17.996749] br-lan: port 1(eth0) entered blocking state [ 18.002220] br-lan: port 1(eth0) entered disabled state [ 18.007947] device eth0 entered promiscuous mode [ 19.628494] eth0: link up (1000Mbps/Full duplex) [ 19.633311] br-lan: port 1(eth0) entered blocking state [ 19.638743] br-lan: port 1(eth0) entered forwarding state [ 25.137046] wlan0: Trigger new scan to find an IBSS to join [ 29.136992] wlan0: Trigger new scan to find an IBSS to join [ 29.177032] wlan0: Creating new IBSS network, BSSID 0a:9e:06:dd:57:f0 [ 73.657038] random: crng init done _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
