From: Petr Cvek <petrcve...@gmail.com>
Hi,
While hacking with my modem in openwrt I've found in the lantiq vrx268 SoC
there is only a support for the processes SMP and not for interrupt
routing. After some looking into vendors released source codes (probably
intel UGW) and by observing SoC's memory map I've found out there is
a second interrupt controller (ICU) for the second VPE. The last patch of
this series adds a support for it. The code is different from intel UGW's
set affinity function, where the interrupt line gets enabled (switched)
to the second ICU. Instead only the cpumask gets changed in my set affinity.
The change will be written into the hardware after the next irq enable call.
This was changed because of stability reasons in the high irq load of
the SoC.
The first part of the series are more or less cosmetic changes of long
names, different types and few fixed warnings from checkpatch. There is
a fix in part 5, where I've found the missing bitfield clear before ORing
with a new value.
The SMP in part 7 changes devicetree definition for a register regions
of the ICU. Previously, there was a region for a single IM (a mask/unmask/
enable/... set for 32 interrupts). Now it is the whole ICU. It match more
the hardware layout. There is no compatibility issue in vanilla, only
openwrt was affected by these devicetrees.
Also in the UGW's ltq_enable_irq(), there was a status bit reset before
the actual IRQ line enable. It was marked as "Bug fix for fake interrupt".
The code seems to work without it (vanilla and new SMP), but I've made
an assert if this bit is set before the actual enable. The assert reported
these IRQ sources:
22:00004000 spi_rx (only when SPI is accessed)
63:00800000 mei_cpe (permanent 1s)
112:00000100 asc_tx
But the code seems to run anyway I didn't include the status bit reset part.
The SMP affinity update is done every IRQ enable, where it extract the first
valid VPE from affinity cpumask. This is standard in the kernel.
The code was tested in nosmp configuration on TPLink W9980B in openwrt tree
(patched kernel v4.14). The lantiq devices other than vrx268 were not
tested.
Discussion on openwrt related parts for lantiq ICU SMP is here (devicetrees,
things not in the vanilla kernel, RFC versions of the patch):
https://patchwork.ozlabs.org/patch/1100832/
Changes since v1:
* Added a define for IM size
* Changed ltq_icu_membase array size to NR_CPUS so for_each_possible_cpu()
will not overflow
* Removed affinity auto rotation (can be add later from v1 if required)
* Commit messages wordings
Petr Cvek (7):
MIPS: lantiq: Move macro directly to iomem function
MIPS: lantiq: Change variables to the same type as the source
MIPS: lantiq: Fix attributes of of_device_id structure
MIPS: lantiq: Remove unused macros
MIPS: lantiq: Fix bitfield masking
MIPS: lantiq: Shorten register names, remove unused macros
MIPS: lantiq: Add SMP support for lantiq interrupt controller
arch/mips/lantiq/irq.c | 177 +++++++++++++++++++++++++++++------------
1 file changed, 126 insertions(+), 51 deletions(-)
--
2.21.0
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
