Hardware
--------
CPU: Qualcomm Atheros QCA9558
RAM: 128M DDR2
FLASH: 16MiB
ETH: 1x Atheros AR8035 (PoE in)
1x Atheros AR8033
WiFi2: QCA9558 3T3R (SiGE SE2565T 2.4 GHz power amp x3)
WiFi5: QCA9880 3T3R (Skyworks 5003L1 5 GHz power amp x3)
BTN: 1x Reset
1x WPS
1x USB eject
LED: 1x LED blue
1x LED red
BEEP: 1x GPIO attached piezo beeper
UART: 3.3V GND TX RX (115200-N-8) (3.3V is pin closest to rear ports)
Dupont 4 pin header
Rear RJ45 serial port non-functional
USB: 1x v2.0
Installation
------------
Make sure you set a password for the root user as prompted on first
setup!
1. Upload OpenWRT sysupgrade image via SSH to the device.
Use /tmp as the destination folder on the device.
User is root, password previously set in the web interface.
2. Install OpenWRT with
> sysupgrade -n -F /tmp/<openwrt-image-name>
Signed-off-by: Django Armstrong <iamdja...@hotmail.com>
---
.../linux/ath79/base-files/etc/board.d/02_network | 3 +-
.../etc/hotplug.d/firmware/11-ath10k-caldata | 1 +
target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts | 83 ++++++++++++++++++++++
target/linux/ath79/image/generic.mk | 8 +++
4 files changed, 94 insertions(+), 1 deletion(-)
create mode 100644 target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts
diff --git a/target/linux/ath79/base-files/etc/board.d/02_network
b/target/linux/ath79/base-files/etc/board.d/02_network
index 3eb0e413f3..6c732d854e 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -62,7 +62,8 @@ ath79_setup_interfaces()
ucidef_add_switch "switch0" \
"0@eth0" "1:lan:1" "3:lan:4" "4:lan:3" "5:lan:2" "2:wan"
;;
- devolo,dvl1200e)
+ devolo,dvl1200e|\
+ devolo,dvl1750e)
ucidef_set_interface_lan "eth0 eth1"
;;
dlink,dir-825-b1)
diff --git
a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 76efa24b52..84e43ceee5 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -90,6 +90,7 @@ case "$FIRMWARE" in
devolo,dvl1200e|\
devolo,dvl1200i|\
devolo,dvl1750c|\
+ devolo,dvl1750e|\
devolo,dvl1750i)
ath10kcal_extract "art" 20480 2116
ath10kcal_patch_mac_crc $(macaddr_add $(mtd_get_mac_binary art
0) -1)
diff --git a/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts
b/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts
new file mode 100644
index 0000000000..2570eb7cea
--- /dev/null
+++ b/target/linux/ath79/dts/qca9558_devolo_dvl1750e.dts
@@ -0,0 +1,83 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca9558_devolo_dvl1xxx.dtsi"
+
+/ {
+ compatible = "devolo,dvl1750e", "qca,qca9557";
+ model = "devolo WiFi pro 1750e";
+
+ aliases {
+ led-boot = &status_blue;
+ led-failsafe = &status_red;
+ led-running = &status_blue;
+ led-upgrade = &status_red;
+ };
+
+ keys {
+ wps {
+ label = "WPS Button";
+ linux,code = <KEY_WPS_BUTTON>;
+ gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ debounce-interval = <60>;
+ };
+
+ usb_eject {
+ label = "USB Eject Button";
+ linux,code = <BTN_0>;
+ linux,input-type = <EV_SW>;
+ gpios = <&gpio 19 GPIO_ACTIVE_LOW>;
+ debounce-interval = <60>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ status_blue: status_blue {
+ label = "dvl1750e:blue:status";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ default-state = "on";
+ };
+
+ status_red: status_red {
+ label = "dvl1750e:red:status";
+ gpios = <&gpio 15 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ beeper {
+ compatible = "gpio-beeper";
+ gpios = <&gpio 4 GPIO_ACTIVE_HIGH>;
+ };
+
+
+ gpio_export {
+ compatible = "gpio-export";
+
+ gpio_usb_power {
+ gpio-export,name = "devolo:power:usb";
+ gpio-export,output = <1>;
+ gpios = <&gpio 11 GPIO_ACTIVE_HIGH>;
+ };
+ };
+};
+
+&usb_phy0 {
+ status = "okay";
+};
+
+&usb0 {
+ status = "okay";
+};
+
+&mdio1 {
+ status = "okay";
+};
+
+ð1 {
+ status = "okay";
+};
diff --git a/target/linux/ath79/image/generic.mk
b/target/linux/ath79/image/generic.mk
index 22ba5305b1..9d0412fe97 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -186,6 +186,14 @@ define Device/devolo_dvl1750c
endef
TARGET_DEVICES += devolo_dvl1750c
+define Device/devolo_dvl1750e
+ ATH_SOC := qca9558
+ DEVICE_TITLE := devolo WiFi pro 1750e
+ DEVICE_PACKAGES := kmod-usb2 kmod-ath10k-ct ath10k-firmware-qca988x-ct
+ IMAGE_SIZE := 15936k
+endef
+TARGET_DEVICES += devolo_dvl1750e
+
define Device/devolo_dvl1750i
ATH_SOC := qca9558
DEVICE_TITLE := devolo WiFi pro 1750i
--
2.11.0
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
