testing update for Nanostation M5 XW:
indeed this entry is needed in 02_network:
ubnt,nano-m-xw)
ucidef_add_switch "switch0" \
"0@eth0" "5:lan" "1:wan"
;;
On a laptop on the LAN, I observe frames egressing (arp requests) and
TX counts triggered by a ping on the device of a laptop IP address.
However, no frames are being received. There were corresponding TX
packet counts with the ping, but always 0 count RX.
The wlan0 was not showing due to defaulted /etc/config/wireless with
"option disabled '1'". I changed this option to '0' and restarted
the network:
wlan0 Link encap:Ethernet HWaddr 04:18:D6:A6:70:B5
inet6 addr: fe80::618:d6ff:fea6:70b5/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:108 errors:0 dropped:0 overruns:0 frame:0
TX packets:120 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:10987 (10.7 KiB) TX bytes:16383 (15.9 KiB)
Success, I am able to connect to SSID "OpenWrt" and access the device via ssh.
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
