+(fix John's email-address) Hi Rafal,
thanks for the feedback. On 06/29/2018 10:44 AM, Rafał Miłecki wrote: > On Thu, 28 Jun 2018 at 17:37, Zefir Kurtisi <zefir.kurt...@neratec.com> wrote: >> What I fail to understand is this: most services are started between S10boot >> and >> S95done, but without jffs2 overlay being mounted, they have no access to the >> current configuration but operate with factory config. Does this make sense, >> or am >> I missing something? > > JFFS2 formatting happens on the first boot only. There is no "current > configuration" then on the flash that would differ from the "factory > config". > There must be something that the jffs2 subsystem is doing every boot, since I regularly get the "jffs2 not ready yet, using temporary tmpfs overlay" message during S10boot when the rootfs_data partition is large (20MB+) - I was speculating on garbage collection or scanning delays. Though, this might be specific to our system (rather slow SPI-NOR flash, active mtd_oops module, etc.). If in essence you are saying this should never happen during regular boot, it helps a lot limiting the potential root causes. Thanks, Zefir _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
