Hi, please try to keep the number of replies low, ideally one.
On Mon, Dec 7, 2015 at 5:05 PM, Josh Bendavid <[email protected]> wrote: > (Sorry about the top posting) > and keep some context to what you are replying to. > For the flash, the stock firmware, and the factory images built with these > patches are using only the NOR flash as far as I know. > > I am not 100% sure whether the NAND is physically there or not (what would > be the easiest way to check?) check for lines like this: [ 0.965016] nand: device found, Manufacturer ID: 0x2c, Chip ID: 0xaa [ 0.966215] nand: Micron MT29F2G08ABBEAH4 [ 0.972816] nand: 256MiB, SLC, page size: 2048, OOB size: 64 On Mon, Dec 7, 2015 at 4:57 PM, Josh Bendavid <[email protected]> wrote: > For the WAN link, I did not test it myself yet with 10 or 100mbps, but the > situation should be the same as described here > https://dev.openwrt.org/changeset/47695/trunk/target/linux/ipq806x That was intended as a hint that your dts file did not include the fix mentioned in the commit, in case it is wired up the same. Jonas _______________________________________________ openwrt-devel mailing list [email protected] https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
