On Fri, Jul 24, 2015 at 1:00 AM, Aleksander Wałęski <olewa...@gmail.com> wrote: > Actually, it just dawned on me that they can be doing just that. In > the bootloader. This is the only part of firmware we are not changing. > If PCBs turn out to be identical we might want to check this. That was my first guess, but I am using the open source u-boot version on the BT Home Hub 5A (= Annex A device) and it still refuses to connect to Annex B (at least back when I tried last, I switched to VDSL like two months ago).
If you can figure out where the boot_sel pins are (similar to [0] or [1]) to get it into CFG04 mode (= boot via UART) then I can add a patch for Daniel Schwierzeck's open source lantiq u-boot. But be aware: you need to pull some of them HIGH (= 3.3V, *NOT* 5V) - you could damage your device by pulling the wrong pin HIGH. Regards, Martin [0] http://wiki.openwrt.org/toh/arcadyan/vgv7510kw22 [1] http://wiki.openwrt.org/toh/bt/homehub_v5a _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
