Hi, I've edited patches from Linux 3.18 to make the MT7628 work with Linux 4.0. OpenWRT launches, I have access to the shell. Next step, I configure the IP address with /etc/config/network and /etc/init.d/network reload. Ifconfig shows me my new address IP.
But, I can't connect via ssh to my board and if I reboot the board, I get errors at boot: [ 10.230000] jffs2: jffs2_scan_inode_node(): CRC failed on node at 0x004725bc: Read 0xffffffff, calculated 0x149094b5 I would say it appears one hundred times with different calculated CRC. and finally the last line is: [ 11.000000] jffs2: notice: (305) jffs2_build_xattr_subsystem: complete building xattr subsystem, 0 of xdatum (0 unchecked, 0 orphan) and 0 of xref (0 dead, 0 orphan) found. Then, I'm able to access to the shell but I still can't connect via ssh. The board constantly reports: [ 2410.010000] ralink_soc_eth 10100000.ethernet eth0: transmit timed out [ 2410.020000] ralink_soc_eth 10100000.ethernet eth0: dma_cfg:00000055 [ 2410.030000] ralink_soc_eth 10100000.ethernet eth0: tx_ring=0, base=00dce000, max=128, ctx=126, dtx=126, fdx=123 [ 2410.050000] ralink_soc_eth 10100000.ethernet eth0: rx_ring=0, base=01a36000, max=128, calc=121, drx=54 [ 2415.010000] ralink_soc_eth 10100000.ethernet eth0: transmit timed out [ 2415.020000] ralink_soc_eth 10100000.ethernet eth0: dma_cfg:00000055 [ 2415.030000] ralink_soc_eth 10100000.ethernet eth0: tx_ring=0, base=00dce000, max=128, ctx=126, dtx=126, fdx=123 [ 2415.050000] ralink_soc_eth 10100000.ethernet eth0: rx_ring=0, base=01a36000, max=128, calc=121, drx=60 It seems to be related to ethernet driver. Does anyone know those errors? Regards, Baptiste _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
