Hi, On Sat, May 30, 2015 at 3:11 AM, Mathieu Olivari <math...@codeaurora.org> wrote: > Ethernet GMAC is built-in the SoC, so there is no need to enable it as a > module. We'll just assume we need it. That's what is done for other > platform where this driver is used so it'll make things more consistent. > > Signed-off-by: Mathieu Olivari <math...@codeaurora.org> > --- > target/linux/ipq806x/Makefile | 2 +- > target/linux/ipq806x/config-3.18 | 10 ++++++++-- > 2 files changed, 9 insertions(+), 3 deletions(-) > > diff --git a/target/linux/ipq806x/Makefile b/target/linux/ipq806x/Makefile > index da841a6..b6ddfe2 100644 > --- a/target/linux/ipq806x/Makefile > +++ b/target/linux/ipq806x/Makefile > @@ -15,7 +15,7 @@ KERNELNAME:=zImage Image dtbs > > include $(INCLUDE_DIR)/target.mk > DEFAULT_PACKAGES += \ > - kmod-leds-gpio kmod-gpio-button-hotplug kmod-stmmac swconfig \ > + kmod-leds-gpio kmod-gpio-button-hotplug swconfig \ > kmod-ata-core kmod-ata-ahci kmod-ata-ahci-platform > > > diff --git a/target/linux/ipq806x/config-3.18 > b/target/linux/ipq806x/config-3.18 > index 396c6e3..4d3b884 100644 > --- a/target/linux/ipq806x/config-3.18 > +++ b/target/linux/ipq806x/config-3.18 > @@ -121,6 +121,7 @@ CONFIG_DMA_ENGINE=y > CONFIG_DMA_OF=y > CONFIG_DMA_VIRTUAL_CHANNELS=y > CONFIG_DTC=y > +CONFIG_DWMAC_IPQ806X=y > # CONFIG_DW_DMAC_CORE is not set > # CONFIG_DW_DMAC_PCI is not set > CONFIG_DYNAMIC_DEBUG=y > @@ -212,7 +213,6 @@ CONFIG_I2C_CHARDEV=y > CONFIG_I2C_COMPAT=y > CONFIG_I2C_HELPER_AUTO=y > CONFIG_I2C_QUP=y > -# CONFIG_IEEE802154 is not set > CONFIG_IKCONFIG=y > CONFIG_IKCONFIG_PROC=y > CONFIG_INITRAMFS_SOURCE="" > @@ -243,7 +243,6 @@ CONFIG_MFD_SYSCON=y > CONFIG_MIGHT_HAVE_CACHE_L2X0=y > CONFIG_MIGHT_HAVE_PCI=y > CONFIG_MIGRATION=y > -# CONFIG_MMC_SDHCI_MSM is not set > CONFIG_MODULES_USE_ELF_REL=y > CONFIG_MSM_GCC_8660=y > CONFIG_MSM_GCC_8960=y > @@ -261,6 +260,7 @@ CONFIG_MUTEX_SPIN_ON_OWNER=y > CONFIG_NEED_DMA_MAP_STATE=y > CONFIG_NEON=y > CONFIG_NET_FLOW_LIMIT=y > +CONFIG_NET_PTP_CLASSIFY=y > CONFIG_NET_VENDOR_WIZNET=y > CONFIG_NO_BOOTMEM=y > CONFIG_NO_HZ=y > @@ -319,12 +319,14 @@ CONFIG_POWER_RESET=y > CONFIG_POWER_RESET_MSM=y > # CONFIG_POWER_RESET_SYSCON is not set > CONFIG_POWER_SUPPLY=y > +CONFIG_PPS=y > CONFIG_PREEMPT=y > CONFIG_PREEMPT_COUNT=y > # CONFIG_PREEMPT_NONE is not set > CONFIG_PREEMPT_RCU=y > CONFIG_PRINTK_TIME=y > CONFIG_PROC_PAGE_MONITOR=y > +CONFIG_PTP_1588_CLOCK=y > CONFIG_QCOM_BAM_DMA=y > CONFIG_QCOM_GSBI=y > CONFIG_QCOM_HFPLL=y > @@ -366,6 +368,10 @@ CONFIG_SPI_MASTER=y > CONFIG_SPI_QUP=y > CONFIG_SPMI=y > CONFIG_SPMI_MSM_PMIC_ARB=y > +# CONFIG_STMMAC_DA is not set
The kmod version had this enabled - is this change intentional? Jonas _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
