> I haven't been able to get the reset button on boot to work for UniFi. > I use UART to pull up the boot-loader. Then use "urescue" to tftp the > UniFi image back on.
reset button works, but it's not easy to get whether it is pressed or not. If a reset button pressed then after a while AP light a pale blue for a couple of seconds then blinks with two colors.
To recover you need an image of jffs2 partition. I made a copy from working system and used this copy for recovery. I wrote it in openwrt with mtd to firmware partition.
The image bundled with a controller contains a bootloader and a kernel, but it lacks a root filesystem. Moreover the stock bootloader can't write this image, so the procedure published in ubiquity forums doesn't work for ap+.
Kirill. _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
