I have a flash image built based on Barrier Breaker's trunk as of today + this patch...in case you Josh or someone else is interested.
-Janne 2015-03-11 21:10 GMT+02:00 Joshua Judson Rosen <jro...@harvestai.com>: > On 2015-03-11 14:48, Janne Cederberg wrote: >> This problem has existed at least since Attitude Adjustment and >> is also present in trunk. Basically on the Hornet-UB board the >> functionality of RESET and WPS have "switched places". >> >> There are two tickets about the issue at dev.openwrt.org, >> The solution suggested on them both is incomplete though >> and introduces the following proglem: >> >> Patching as suggested on #14136/#15282 will result in a situation >> where simply pressing the RESET button on the bottom will cause >> FACTORY RESET to be run. This is due to GPIO high/low state being >> incorrect as a result of the above change and virtually the RESET >> button is in the pressed-down state the entire time. When it is >> then physically pressed, that causes the opposite, release, to be >> triggered and since to the board it seemed that the button was >> pressed long before it was released, the FACTORY RESET results. >> >> The attached patch works as expected. > > > Interesting--I don't have a good excuse for why I missed that fact myself, > but thanks a bunch for picking the issue/patch up and running with it! > > I'm still doing a bunch of work with the Hornet-UB devices, so I'll > be quite delighted if this makes it into a release :) > > -- > "Don't be afraid to ask (λf.((λx.xx) (λr.f(rr))))." _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
