* Claudio Leite (lei...@staticky.com) wrote: > This sets 'enable_vlan' and thus uses 802.1q > VLANs, but without tagging on either interface.
Note: this depends on the previous patch, since setting up the switch when both interfaces have the same MAC address results in a ton of packet loss. This might be a bug in the switch driver. It may be related that with the current setup (i.e. without either of these patches) I see a lot of [ 65.401622] br-lan: received packet on eth0 with own address as source address while running NAT routing tests between two PCs, using both LAN and WAN interfaces. They seem to go away once I change the MAC (patch 1 only) which then also allows the setup from this patch to work. However, I might be mixed up as to what the cause is, since I haven't looked into this too deeply yet. Any insight is appreciated. It's worth noting the original Linksys firmware seems to use the same MAC on both interfaces. -Claudio > > Signed-off-by: Claudio Leite <lei...@staticky.com> > --- > target/linux/mvebu/base-files/etc/uci-defaults/02_network | 3 +++ > 1 file changed, 3 insertions(+) > > diff --git a/target/linux/mvebu/base-files/etc/uci-defaults/02_network > b/target/linux/mvebu/base-files/etc/uci-defaults/02_network > index 8b1ed6a..9464f36 100644 > --- a/target/linux/mvebu/base-files/etc/uci-defaults/02_network > +++ b/target/linux/mvebu/base-files/etc/uci-defaults/02_network > @@ -17,6 +17,9 @@ board=$(mvebu_board_name) > case "$board" in > armada-xp-mamba) > ucidef_set_interfaces_lan_wan "eth0" "eth1" > + ucidef_add_switch "switch0" "1" "1" > + ucidef_add_switch_vlan "switch0" "1" "0 1 2 3 5" > + ucidef_add_switch_vlan "switch0" "2" "4 6" > ;; > > *) > -- > 2.1.4 > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
