Set the default configuration for the switch so that is consistent with how it
was configured by u-Boot. These changes are essentially identical to:
https://dev.openwrt.org/browser/trunk/target/linux/kirkwood/base-files/etc/uci-defaults/02_network?rev=43750
Signed-off-by: Mark Milburn <mark.a.milb...@gmail.com>
---
.../linux/mvebu/base-files/etc/uci-defaults/02_network | 16 ++++++++++++++++
1 file changed, 16 insertions(+)
diff --git a/target/linux/mvebu/base-files/etc/uci-defaults/02_network
b/target/linux/mvebu/base-files/etc/uci-defaults/02_network
index 8b1ed6a..a17b239 100644
--- a/target/linux/mvebu/base-files/etc/uci-defaults/02_network
+++ b/target/linux/mvebu/base-files/etc/uci-defaults/02_network
@@ -7,6 +7,19 @@
touch /etc/config/network
+add_port_based_vlan() {
+ local device=$1
+ local vlan=$2
+ local ports=$3
+ uci batch <<EOF
+add network switch_vlan
+set network.@switch_vlan[-1].device='$device'
+set network.@switch_vlan[-1].vlan='$vlan'
+set network.@switch_vlan[-1].ports='$ports'
+set network.@switch_vlan[-1].port_based='1'
+EOF
+}
+
. /lib/functions/uci-defaults.sh
. /lib/mvebu.sh
@@ -17,6 +30,9 @@ board=$(mvebu_board_name)
case "$board" in
armada-xp-mamba)
ucidef_set_interfaces_lan_wan "eth0" "eth1"
+ ucidef_add_switch "switch0" "1" "0"
+ add_port_based_vlan "switch0" "1" "0 1 2 3 5"
+ add_port_based_vlan "switch0" "2" "4 6"
;;
*)
--
2.2.1
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
