mpc85xx: fix WAN/LAN-MAC for TP-LINK TL-WDR4900 v1 This works around a bootloader issue and reads the macs from config-partition during initial network setup. We have 9 valid macs stored in the partition, the 1st two are used for the radios, 3 and 4 are now used for WAN/LAN.
https://dev.openwrt.org/ticket/14714 Signed-off-by: Bastian Bittorf <bitt...@bluebottle.com> --- .../mpc85xx/base-files/etc/uci-defaults/02_network | 26 ++++---------------- 1 files changed, 5 insertions(+), 21 deletions(-) diff --git a/target/linux/mpc85xx/base-files/etc/uci-defaults/02_network b/target/linux/mpc85xx/base-files/etc/uci-defaults/02_network index 10a2cc8..e4e3566 100755 --- a/target/linux/mpc85xx/base-files/etc/uci-defaults/02_network +++ b/target/linux/mpc85xx/base-files/etc/uci-defaults/02_network @@ -1,22 +1,5 @@ #!/bin/sh -# -# Copyright (C) 2013 OpenWrt.org -# - -tplink_set_mac() -{ - local cfg=$1 - local offset=$2 - local mac - - . /lib/functions.sh - - mac=$(mtd_get_mac_binary u-boot 326656) - mac=$(macaddr_add $mac $offset) - - ucidef_set_interface_macaddr $cfg $mac -} - +# Copyright (C) 2014 OpenWrt.org [ -e /etc/config/network ] && exit 0 @@ -24,6 +7,8 @@ touch /etc/config/network . /lib/functions/uci-defaults.sh . /lib/mpc85xx.sh +. /lib/functions.sh +. /lib/functions/system.sh ucidef_set_interface_loopback @@ -35,10 +20,9 @@ tl-wdr4900-v1) ucidef_add_switch "switch0" "1" "1" ucidef_add_switch_vlan "switch0" "1" "0t 2 3 4 5" ucidef_add_switch_vlan "switch0" "2" "0t 1" - tplink_set_mac lan -2 - tplink_set_mac wan 1 + ucidef_set_interface_macaddr lan "$(mtd_get_mac_binary config 338)" + ucidef_set_interface_macaddr wan "$(mtd_get_mac_binary config 344)" ;; - *) ucidef_set_interfaces_lan_wan "eth0" "eth1" ;; -- 1.7.2.5 _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
