* Roman Yeryomin (leroi.li...@gmail.com) wrote:
> On 8 April 2014 19:41, Claudio Leite <lei...@staticky.com> wrote:
> > * Roman Yeryomin (leroi.li...@gmail.com) wrote:
> > I think by default it configures mdio as mdio--I had a mdio_pins group
> > in my rt2880.dtsi, but when I submitted the patches I redid the
> > ethernet port stuff against the one you submitted. It worked fine
> > despite not linking or otherwise configuring the mdio pins. So, just
> > removing that one entry should do the trick.
>
> Without mdio pins set the switch driver cannot identify it at all. I
> know in older versions (pre DTs) the mdio pins were not touched. I'm
> not sure about the actual reason but it seems strange to me also.
I see, is that with mdio configured explicitly to be mdio, or gpio?
The rtl8366 is configured differently from the IP175E in my router so
what works for me might not for you.
> Also I've sent another one to fix eeprom extraction which was broken
> by Felix recently.
It's possible to do that from the dts as well:
wmac@480000 {
status = "okay";
ralink,mtd-eeprom = <&factory 0>;
};
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
