This is happening on my hardware/routers as well upon fresh install of OpenWrt factory images (have not tested sysupgrade). Hardware: WD My Net N750 LED keeps blinking during boot immediately after the flash and never stops blinking (Until reboot).
On Fri, Feb 7, 2014 at 6:36 PM, Rafał Miłecki <zaj...@gmail.com> wrote: > I'm using bcm47xx. > > On the first boot after installation OpenWrt starts linking my LED and > never stops. It starts around > > Press the [f] key and hit [enter] to enter failsafe mode > > Press the [1], [2], [3] or [4] key and hit [enter] to select the debug > level > > Ofc I was waiting for few minutes, even after preparing JFFS2 > partition LED keeps blinking. > > On another boot this problem doesn't occur. > > My guess is that set_state (/etc/diag.sh) is never called with "done" > argument on the first boot. > > -- > Rafał > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel >
_______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
