I run current trunk on a wrt610n v2 without applying any patches, and without observing any of the issues mentioned. Also, that kernel is ancient (Was this email stalled for 2 years somewhere in the depths of the web?).
On Sat, Dec 18, 2010 at 2:19 AM, Nathan Hintz <nlhi...@hotmail.com> wrote: > The patches being referred to can be found in this thread > (https://lists.openwrt.org/pipermail/openwrt-devel/2010-May/007049.html). I > have applied them with modifications to a recent version of trunk and the > 2.6.37-rc6 kernel; and modified the build to produce a bootable image for a > Linksys E3000 (same H/W as WRT610Nv2). The modifications include changes > for the WRT610Nv2, but I have not tested that image to see if it loads (no > H/W to test on). > > > > The image has the same problems as mentioned previously (no Ethernet, no > wireless, no USB, no switch support); you need to have serial access to do > anything with it. There are also issues with reading from NVRAM (some work, > some don’t) that I looked into a little but didn’t figure out; so the board > detection (in broadcom-diag) doesn’t work. The broadcom-wl driver loads > (w/ a small patch) and creates an interface; but when the interface is > brought up, it causes a kernel oops followed by a reboot. > > > > The patches from the link above disable support for the PCI-E core. I > suspect this needs to be fixed, before we will get very far. This was what > I was going to look at next, but it will be slow going since I have to > educate myself before I can make sense of it. If someone knows how this all > works, I could really use some help with this or some pointers to send me in > the right direction so I’m not wasting effort. > > > > Nathan > > > _______________________________________________ > openwrt-devel mailing list > openwrt-devel@lists.openwrt.org > https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel > _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
