Hi,
First start with gainig console access...
Then you need to check what boot loader is there.
Depending on what it is your next steps will vary, let's hope it's
supported one :)
On 17.10.2013 11:16, Marco Antonio Mauro wrote:
Hi everyone,
I have a Thomson TG585v8 Amazon-SE device.
The device seems almost identical to the Netgear DGN1000B already in
openwrt, and I'd like to add support for the specific board. But can't
seem to figure out how to do it. I previously added support for a
ralink device but the process seems different here.
The board has:
- Lantiq PSB50601HL v1.2 Processor, supposedly clocked at 266MHz
- Winbond W25Q64BV SPI flash, 8MBytes
- Winbond W9825G6H SDRAM, 32MBytes total
- Broadcom BCM5325E switch
- USB2 wifi card for AP, can't remove the EMI shield to confirm model
but probably Atheros AR9271
- a couple buttons and leds.
Can anyone give me some pointers on what to do?
Thank you!
PS: I'll add the device with the photos of the board to the wiki later
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/cgi-bin/mailman/listinfo/openwrt-devel
