John Crispin wrote:
> On 06/04/13 18:47, Tobias Diedrich wrote:
> >+
> >+ gpio-leds {
> >+ compatible = "gpio-leds";
> >+ // Used to enable power-over-ethernet passthrough from port0 to
> >port1.
> >+ // Disable passthrough by default to prevent accidental
> >equipment damage.
> >+ poe {
> >+ label = "freestation:poe:passthrough";
> >+ gpios =<&gpio0 11 1>;
> >+ };
> >+ // The following leds are defined in the ArcOS firmware, but
> >reportedly
> >+ // not present in the Freestation5 device.
>
> Hi,
>
> this should be done with an of_gpio_export node
> ->
> https://dev.openwrt.org/browser/trunk/target/linux/ramips/dts/DIR-645.dts#L134
Hmm, annoyingly that does not seem to allow setting defaults values
other than direction.
But I'd like to set it to active_low and off by default.
--
Tobias PGP: http://8ef7ddba.uguu.de
_______________________________________________
openwrt-devel mailing list
openwrt-devel@lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
