Hi, I've been working on porting OpenWRT to the Option GlobeSurfer II, a BCM5325-based platform with 16MB flash, a built-in USB 3G modem, Si3210 telephone interface and 128x64 pixel OLED display. It's usually distributed as a wireless broadband modem/telephone line solution, as far as I can tell. The default firmware is OpenRG-based, and I'm not sure how unusual that is (so far it seems the CFE doesn't accept standard TRXes, divides flash into sections, and won't boot unless the boot section starts with a header that has a valid checksum).
I asked in IRC about how best to implement board detection since it doesn't seem to have any of the nvram fields typically used for board detection, and a couple of people asked me to post the contents of NVRAM to the board, so here it is: ----START OF NVRAM---- opo=12 il0macaddr=00:0C:E3:61:BB:78 boardrev=0x13 et0macaddr=00:0C:E3:61:BB:79 watchdog=3000 boot_wait=on et0mdcport=0 pmon_ver=CFE 3.131.35.0 display_type=6sDl2C vlan0ports=5 sromrev=2 boardtype=0x467 lan_netmask=255.255.255.0 wl0id=0x4318 ag0=2 wl0gpio0=11 wl0gpio1=11 wl0gpio2=11 wl0gpio3=11 wait_time=3 pa0itssit=62 cctl=0 pa0maxpwr=66 lan_ipaddr=192.168.1.1 clkfreq=200 aa0=3 sdram_config=0x62 vlan1ports=0 5* ccode=0 boardflags=0x1758 wandevs=et0 sdram_refresh=0 sdram_ncdl=0xfc0008 et0phyaddr=30 anim_type=6sDl2C landevs=vlan0 wl0 pa0b0=0x15ee pa0b1=0xfa80 pa0b2=0xfe87 sdram_init=0x0b vlan0hwname=et0 boardnum=G33779F3NR ----END OF NVRAM---- Regards, Fiach Antaw _______________________________________________ openwrt-devel mailing list openwrt-devel@lists.openwrt.org https://lists.openwrt.org/mailman/listinfo/openwrt-devel
